| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| In the Linux kernel, the following vulnerability has been resolved:
scsi: mpi3mr: Sanitise num_phys
Information is stored in mr_sas_port->phy_mask, values larger then size of
this field shouldn't be allowed. |
| Issue summary: An OpenSSL TLS 1.3 server may fail to negotiate the expected
preferred key exchange group when its key exchange group configuration includes
the default by using the 'DEFAULT' keyword.
Impact summary: A less preferred key exchange may be used even when a more
preferred group is supported by both client and server, if the group
was not included among the client's initial predicated keyshares.
This will sometimes be the case with the new hybrid post-quantum groups,
if the client chooses to defer their use until specifically requested by
the server.
If an OpenSSL TLS 1.3 server's configuration uses the 'DEFAULT' keyword to
interpolate the built-in default group list into its own configuration, perhaps
adding or removing specific elements, then an implementation defect causes the
'DEFAULT' list to lose its 'tuple' structure, and all server-supported groups
were treated as a single sufficiently secure 'tuple', with the server not
sending a Hello Retry Request (HRR) even when a group in a more preferred tuple
was mutually supported.
As a result, the client and server might fail to negotiate a mutually supported
post-quantum key agreement group, such as 'X25519MLKEM768', if the client's
configuration results in only 'classical' groups (such as 'X25519' being the
only ones in the client's initial keyshare prediction).
OpenSSL 3.5 and later support a new syntax for selecting the most preferred TLS
1.3 key agreement group on TLS servers. The old syntax had a single 'flat'
list of groups, and treated all the supported groups as sufficiently secure.
If any of the keyshares predicted by the client were supported by the server
the most preferred among these was selected, even if other groups supported by
the client, but not included in the list of predicted keyshares would have been
more preferred, if included.
The new syntax partitions the groups into distinct 'tuples' of roughly
equivalent security. Within each tuple the most preferred group included among
the client's predicted keyshares is chosen, but if the client supports a group
from a more preferred tuple, but did not predict any corresponding keyshares,
the server will ask the client to retry the ClientHello (by issuing a Hello
Retry Request or HRR) with the most preferred mutually supported group.
The above works as expected when the server's configuration uses the built-in
default group list, or explicitly defines its own list by directly defining the
various desired groups and group 'tuples'.
No OpenSSL FIPS modules are affected by this issue, the code in question lies
outside the FIPS boundary.
OpenSSL 3.6 and 3.5 are vulnerable to this issue.
OpenSSL 3.6 users should upgrade to OpenSSL 3.6.2 once it is released.
OpenSSL 3.5 users should upgrade to OpenSSL 3.5.6 once it is released.
OpenSSL 3.4, 3.3, 3.0, 1.0.2 and 1.1.1 are not affected by this issue. |
| A problem with a protection mechanism in the Palo Alto Networks Cortex XDR agent on macOS allows a local administrator to disable the agent. This issue could be leveraged by malware to perform malicious activity without detection. |
| Improper Check of minimum version in update functionality of certain Zoom Clients for Windows may allow an authenticated user to conduct an escalation of privilege via local access. |
| matrix-sdk-base is the base component to build a Matrix client library. Versions 0.14.1 and prior are unable to handle responses that include custom m.room.join_rules values due to a serialization bug. This can be exploited to cause a denial-of-service condition, if a user is invited to a room with non-standard join rules, the crate's sync process will stall, preventing further processing for all rooms. This is fixed in version 0.16.0. |
| Improper handling of exceptional conditions in VX800v v1.0 in SIP processing allows an attacker to flood the device with crafted INVITE messages, blocking all voice lines and causing a denial of service on incoming calls. |
| SIPGO is a library for writing SIP services in the GO language. Starting in version 0.3.0 and prior to version 1.0.0-alpha-1, a nil pointer dereference vulnerability is in the SIPGO library's `NewResponseFromRequest` function that affects all normal SIP operations. The vulnerability allows remote attackers to crash any SIP application by sending a single malformed SIP request without a To header. The vulnerability occurs when SIP message parsing succeeds for a request missing the To header, but the response creation code assumes the To header exists without proper nil checks. This affects routine operations like call setup, authentication, and message handling - not just error cases. This vulnerability affects all SIP applications using the sipgo library, not just specific configurations or edge cases, as long as they make use of the `NewResponseFromRequest` function. Version 1.0.0-alpha-1 contains a patch for the issue. |
| Memory corruption during memory assignment to headless peripheral VM due to incorrect error code handling. |
| A vulnerability in the CLI of Cisco IOS XE Software could allow an authenticated, local attacker with privilege level 15 to elevate privileges to root on the underlying operating system of an affected device.
This vulnerability is due to insufficient input validation when processing specific configuration commands. An attacker could exploit this vulnerability by including crafted input in specific configuration commands. A successful exploit could allow the attacker to elevate privileges to root on the underlying operating system of an affected device. The security impact rating (SIR) of this advisory has been raised to High because an attacker could gain access to the underlying operating system of the affected device and perform potentially undetected actions.
Note: The attacker must have privileges to enter configuration mode on the affected device. This is usually referred to as privilege level 15. |
| A vulnerability in the CLI of Cisco IOS XE Software could allow an authenticated, local attacker with privilege level 15 to elevate privileges to root on the underlying operating system of an affected device.
This vulnerability is due to insufficient input validation when processing specific configuration commands. An attacker could exploit this vulnerability by including crafted input in specific configuration commands. A successful exploit could allow the attacker to elevate privileges to root on the underlying operating system of an affected device. The security impact rating (SIR) of this advisory has been raised to High because an attacker could gain access to the underlying operating system of the affected device and perform potentially undetected actions.
Note: The attacker must have privileges to enter configuration mode on the affected device. This is usually referred to as privilege level 15. |
| A vulnerability in the CLI of Cisco IOS XE Software could allow an authenticated, local attacker with privilege level 15 to elevate privileges to root on the underlying operating system of an affected device.
This vulnerability is due to insufficient input validation when processing specific configuration commands. An attacker could exploit this vulnerability by including crafted input in specific configuration commands. A successful exploit could allow the attacker to elevate privileges to root on the underlying operating system of an affected device. The security impact rating (SIR) of this advisory has been raised to High because an attacker could gain access to the underlying operating system of the affected device and perform potentially undetected actions.
Note: The attacker must have privileges to enter configuration mode on the affected device. This is usually referred to as privilege level 15. |
| Improper handling of insufficient permissions or privileges in Microsoft Dataverse allows an authorized attacker to elevate privileges over a network. |
| In VerifyNoOverlapInSessions of apexd.cpp, there is a possible way to block security updates due to a logic error in the code. This could lead to local escalation of privilege with no additional execution privileges needed. User interaction is not needed for exploitation. |
| free5gc UDM provides Unified Data Management (UDM) for free5GC, an open-source project for 5th generation (5G) mobile core networks. In versions up to and including 1.4.1, the service reliably leaks detailed internal error messages (e.g., strconv.ParseInt parsing errors) to remote clients when processing invalid pduSessionId inputs. This exposes implementation details and can be used for service fingerprinting. All deployments of free5GC using the UDM Nudm_UECM DELETE service may be vulnerable. free5gc/udm pull request 76 contains a fix for the issue. No direct workaround is available at the application level. Applying the official patch is recommended. |
| A vulnerability has been identified in SINEC INS (All versions < V1.0 SP2 Update 2). The Web UI of affected devices does not check the length of parameters in certain conditions. This allows a malicious admin to crash the server by sending a crafted request to the server. The server will automatically restart. |
| An improper check for unusual conditions in Zyxel NWA110AX firmware verisons prior to 6.50(ABTG.0)C0, which could allow a LAN attacker to cause a temporary denial-of-service (DoS) by sending crafted VLAN frames if the MAC address of the vulnerable AP were intercepted by the attacker. |
| An issue was discovered in Joomla! 2.5.0 through 3.9.27. Install action in com_installer lack the required hardcoded ACL checks for superusers. A default system is not affected cause the default ACL for com_installer is limited to super users already. |
| <p>An elevation of privilege vulnerability exists when the Windows Language Pack Installer improperly handles file operations. An attacker who successfully exploited this vulnerability could run processes in an elevated context.</p>
<p>An attacker could exploit this vulnerability by running a specially crafted application on the victim system.</p>
<p>The update addresses the vulnerability by correcting the way the Windows Language Pack Installer handles file operations.</p> |
| <p>An elevation of privilege vulnerability exists when Windows Error Reporting manager improperly handles a process crash. An attacker who successfully exploited this vulnerability could delete a targeted file leading to an elevated status.</p>
<p>To exploit this vulnerability, an attacker would first have to log on to the system. An attacker could then run a specially crafted application that could exploit the vulnerability and take control of an affected system.</p>
<p>The security update addresses the vulnerability by correcting how Windows Error Reporting manager handles process crashes.</p> |
| An Improper Check for Unusual or
Exceptional Conditions vulnerability in Brocade Fabric OS before 9.2.2.a
could allow an authenticated, network-based attacker to cause a
Denial-of-Service (DoS).
The
vulnerability is encountered when supportsave is invoked remotely,
using ssh command or SANnav inline ssh, and the corresponding ssh
session is terminated with Control C (^c ) before supportsave
completion.
This issue affects Brocade Fabric OS 9.0.0 through 9.2.2 |
