| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| In Janitza GridVis through 9.0.66, exposed dangerous methods in the de.janitza.pasw.project.server.ServerDatabaseProject project load functionality allow remote authenticated administrative users to execute arbitrary Groovy code. |
| A vulnerability classified as problematic has been found in Zhejiang Land Zongheng Network Technology O2OA up to 20240403. Affected is an unknown function of the file /x_portal_assemble_surface/jaxrs/portal/list?v=8.2.3-4-43f4fe3. The manipulation leads to information disclosure. It is possible to launch the attack remotely. The complexity of an attack is rather high. The exploitability is told to be difficult. The exploit has been disclosed to the public and may be used. VDB-260478 is the identifier assigned to this vulnerability. NOTE: The vendor was contacted early about this disclosure but did not respond in any way. |
| In the Linux kernel, the following vulnerability has been resolved:
dmaengine: dw-edma: HDMA: Add sync read before starting the DMA transfer in remote setup
The Linked list element and pointer are not stored in the same memory as
the HDMA controller register. If the doorbell register is toggled before
the full write of the linked list a race condition error will occur.
In remote setup we can only use a readl to the memory to assure the full
write has occurred. |
| In the Linux kernel, the following vulnerability has been resolved:
phonet/pep: fix racy skb_queue_empty() use
The receive queues are protected by their respective spin-lock, not
the socket lock. This could lead to skb_peek() unexpectedly
returning NULL or a pointer to an already dequeued socket buffer. |
| In the Linux kernel, the following vulnerability has been resolved:
Revert "net/mlx5: Block entering switchdev mode with ns inconsistency"
This reverts commit 662404b24a4c4d839839ed25e3097571f5938b9b.
The revert is required due to the suspicion it is not good for anything
and cause crash. |
| In the Linux kernel, the following vulnerability has been resolved:
Revert "drm/amd/pm: resolve reboot exception for si oland"
This reverts commit e490d60a2f76bff636c68ce4fe34c1b6c34bbd86.
This causes hangs on SI when DC is enabled and errors on driver
reboot and power off cycles. |
| In the Linux kernel, the following vulnerability has been resolved:
io_uring/af_unix: disable sending io_uring over sockets
File reference cycles have caused lots of problems for io_uring
in the past, and it still doesn't work exactly right and races with
unix_stream_read_generic(). The safest fix would be to completely
disallow sending io_uring files via sockets via SCM_RIGHT, so there
are no possible cycles invloving registered files and thus rendering
SCM accounting on the io_uring side unnecessary. |
| In the Linux kernel, the following vulnerability has been resolved:
xen/evtchn: avoid WARN() when unbinding an event channel
When unbinding a user event channel, the related handler might be
called a last time in case the kernel was built with
CONFIG_DEBUG_SHIRQ. This might cause a WARN() in the handler.
Avoid that by adding an "unbinding" flag to struct user_event which
will short circuit the handler. |
| In the Linux kernel, the following vulnerability has been resolved:
ovl: relax WARN_ON in ovl_verify_area()
syzbot hit an assertion in copy up data loop which looks like it is
the result of a lower file whose size is being changed underneath
overlayfs.
This type of use case is documented to cause undefined behavior, so
returning EIO error for the copy up makes sense, but it should not be
causing a WARN_ON assertion. |
| SourceCodester Web-based Pharmacy Product Management System 1.0 is vulnerable to Incorrect Access Control, which allows low-privileged users to forge high privileged (such as admin) sessions and perform sensitive operations such as adding new users. |
| Amazon Fire OS 7 before 7.6.6.9 and 8 before 8.1.0.3 allows Fire TV applications to establish local ADB (Android Debug Bridge) connections. NOTE: some third parties dispute whether this has security relevance, because an ADB connection is only possible after the (non-default) ADB Debugging option is enabled, and after the initiator of that specific connection attempt has been approved via a full-screen prompt. |
| In the Linux kernel, the following vulnerability has been resolved:
tcp: fix page frag corruption on page fault
Steffen reported a TCP stream corruption for HTTP requests
served by the apache web-server using a cifs mount-point
and memory mapping the relevant file.
The root cause is quite similar to the one addressed by
commit 20eb4f29b602 ("net: fix sk_page_frag() recursion from
memory reclaim"). Here the nested access to the task page frag
is caused by a page fault on the (mmapped) user-space memory
buffer coming from the cifs file.
The page fault handler performs an smb transaction on a different
socket, inside the same process context. Since sk->sk_allaction
for such socket does not prevent the usage for the task_frag,
the nested allocation modify "under the hood" the page frag
in use by the outer sendmsg call, corrupting the stream.
The overall relevant stack trace looks like the following:
httpd 78268 [001] 3461630.850950: probe:tcp_sendmsg_locked:
ffffffff91461d91 tcp_sendmsg_locked+0x1
ffffffff91462b57 tcp_sendmsg+0x27
ffffffff9139814e sock_sendmsg+0x3e
ffffffffc06dfe1d smb_send_kvec+0x28
[...]
ffffffffc06cfaf8 cifs_readpages+0x213
ffffffff90e83c4b read_pages+0x6b
ffffffff90e83f31 __do_page_cache_readahead+0x1c1
ffffffff90e79e98 filemap_fault+0x788
ffffffff90eb0458 __do_fault+0x38
ffffffff90eb5280 do_fault+0x1a0
ffffffff90eb7c84 __handle_mm_fault+0x4d4
ffffffff90eb8093 handle_mm_fault+0xc3
ffffffff90c74f6d __do_page_fault+0x1ed
ffffffff90c75277 do_page_fault+0x37
ffffffff9160111e page_fault+0x1e
ffffffff9109e7b5 copyin+0x25
ffffffff9109eb40 _copy_from_iter_full+0xe0
ffffffff91462370 tcp_sendmsg_locked+0x5e0
ffffffff91462370 tcp_sendmsg_locked+0x5e0
ffffffff91462b57 tcp_sendmsg+0x27
ffffffff9139815c sock_sendmsg+0x4c
ffffffff913981f7 sock_write_iter+0x97
ffffffff90f2cc56 do_iter_readv_writev+0x156
ffffffff90f2dff0 do_iter_write+0x80
ffffffff90f2e1c3 vfs_writev+0xa3
ffffffff90f2e27c do_writev+0x5c
ffffffff90c042bb do_syscall_64+0x5b
ffffffff916000ad entry_SYSCALL_64_after_hwframe+0x65
The cifs filesystem rightfully sets sk_allocations to GFP_NOFS,
we can avoid the nesting using the sk page frag for allocation
lacking the __GFP_FS flag. Do not define an additional mm-helper
for that, as this is strictly tied to the sk page frag usage.
v1 -> v2:
- use a stricted sk_page_frag() check instead of reordering the
code (Eric) |
| In the Linux kernel, the following vulnerability has been resolved:
ipv6: mcast: remove one synchronize_net() barrier in ipv6_mc_down()
As discussed in the past (commit 2d3916f31891 ("ipv6: fix skb drops
in igmp6_event_query() and igmp6_event_report()")) I think the
synchronize_net() call in ipv6_mc_down() is not needed.
Under load, synchronize_net() can last between 200 usec and 5 ms.
KASAN seems to agree as well. |
| In the Linux kernel, the following vulnerability has been resolved:
wifi: wilc1000: do not realloc workqueue everytime an interface is added
Commit 09ed8bfc5215 ("wilc1000: Rename workqueue from "WILC_wq" to
"NETDEV-wq"") moved workqueue creation in wilc_netdev_ifc_init in order to
set the interface name in the workqueue name. However, while the driver
needs only one workqueue, the wilc_netdev_ifc_init is called each time we
add an interface over a phy, which in turns overwrite the workqueue with a
new one. This can be observed with the following commands:
for i in $(seq 0 10)
do
iw phy phy0 interface add wlan1 type managed
iw dev wlan1 del
done
ps -eo pid,comm|grep wlan
39 kworker/R-wlan0
98 kworker/R-wlan1
102 kworker/R-wlan1
105 kworker/R-wlan1
108 kworker/R-wlan1
111 kworker/R-wlan1
114 kworker/R-wlan1
117 kworker/R-wlan1
120 kworker/R-wlan1
123 kworker/R-wlan1
126 kworker/R-wlan1
129 kworker/R-wlan1
Fix this leakage by putting back hif_workqueue allocation in
wilc_cfg80211_init. Regarding the workqueue name, it is indeed relevant to
set it lowercase, however it is not attached to a specific netdev, so
enforcing netdev name in the name is not so relevant. Still, enrich the
name with the wiphy name to make it clear which phy is using the workqueue. |
| In the Linux kernel, the following vulnerability has been resolved:
leds: trigger: netdev: Fix kernel panic on interface rename trig notify
Commit d5e01266e7f5 ("leds: trigger: netdev: add additional specific link
speed mode") in the various changes, reworked the way to set the LINKUP
mode in commit cee4bd16c319 ("leds: trigger: netdev: Recheck
NETDEV_LED_MODE_LINKUP on dev rename") and moved it to a generic function.
This changed the logic where, in the previous implementation the dev
from the trigger event was used to check if the carrier was ok, but in
the new implementation with the generic function, the dev in
trigger_data is used instead.
This is problematic and cause a possible kernel panic due to the fact
that the dev in the trigger_data still reference the old one as the
new one (passed from the trigger event) still has to be hold and saved
in the trigger_data struct (done in the NETDEV_REGISTER case).
On calling of get_device_state(), an invalid net_dev is used and this
cause a kernel panic.
To handle this correctly, move the call to get_device_state() after the
new net_dev is correctly set in trigger_data (in the NETDEV_REGISTER
case) and correctly parse the new dev. |
| In the Linux kernel, the following vulnerability has been resolved:
clk: hisilicon: hi3559a: Fix an erroneous devm_kfree()
'p_clk' is an array allocated just before the for loop for all clk that
need to be registered.
It is incremented at each loop iteration.
If a clk_register() call fails, 'p_clk' may point to something different
from what should be freed.
The best we can do, is to avoid this wrong release of memory. |
| In the Linux kernel, the following vulnerability has been resolved:
powerpc/32: Fix hardlockup on vmap stack overflow
Since the commit c118c7303ad5 ("powerpc/32: Fix vmap stack - Do not
activate MMU before reading task struct") a vmap stack overflow
results in a hard lockup. This is because emergency_ctx is still
addressed with its virtual address allthough data MMU is not active
anymore at that time.
Fix it by using a physical address instead. |
| In the Linux kernel, the following vulnerability has been resolved:
net: stmmac: Disable Tx queues when reconfiguring the interface
The Tx queues were not disabled in situations where the driver needed to
stop the interface to apply a new configuration. This could result in a
kernel panic when doing any of the 3 following actions:
* reconfiguring the number of queues (ethtool -L)
* reconfiguring the size of the ring buffers (ethtool -G)
* installing/removing an XDP program (ip l set dev ethX xdp)
Prevent the panic by making sure netif_tx_disable is called when stopping
an interface.
Without this patch, the following kernel panic can be observed when doing
any of the actions above:
Unable to handle kernel paging request at virtual address ffff80001238d040
[....]
Call trace:
dwmac4_set_addr+0x8/0x10
dev_hard_start_xmit+0xe4/0x1ac
sch_direct_xmit+0xe8/0x39c
__dev_queue_xmit+0x3ec/0xaf0
dev_queue_xmit+0x14/0x20
[...]
[ end trace 0000000000000002 ]--- |
| In the Linux kernel, the following vulnerability has been resolved:
ASoC: SOF: ipc4-pcm: Workaround for crashed firmware on system suspend
When the system is suspended while audio is active, the
sof_ipc4_pcm_hw_free() is invoked to reset the pipelines since during
suspend the DSP is turned off, streams will be re-started after resume.
If the firmware crashes during while audio is running (or when we reset
the stream before suspend) then the sof_ipc4_set_multi_pipeline_state()
will fail with IPC error and the state change is interrupted.
This will cause misalignment between the kernel and firmware state on next
DSP boot resulting errors returned by firmware for IPC messages, eventually
failing the audio resume.
On stream close the errors are ignored so the kernel state will be
corrected on the next DSP boot, so the second boot after the DSP panic.
If sof_ipc4_trigger_pipelines() is called from sof_ipc4_pcm_hw_free() then
state parameter is SOF_IPC4_PIPE_RESET and only in this case.
Treat a forced pipeline reset similarly to how we treat a pcm_free by
ignoring error on state sending to allow the kernel's state to be
consistent with the state the firmware will have after the next boot. |
| In the Linux kernel, the following vulnerability has been resolved:
f2fs: compress: fix to guarantee persisting compressed blocks by CP
If data block in compressed cluster is not persisted with metadata
during checkpoint, after SPOR, the data may be corrupted, let's
guarantee to write compressed page by checkpoint. |
