| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| In the Linux kernel, the following vulnerability has been resolved:
wifi: ath12k: Fix invalid data access in ath12k_dp_rx_h_undecap_nwifi
In certain cases, hardware might provide packets with a
length greater than the maximum native Wi-Fi header length.
This can lead to accessing and modifying fields in the header
within the ath12k_dp_rx_h_undecap_nwifi function for
DP_RX_DECAP_TYPE_NATIVE_WIFI decap type and
potentially resulting in invalid data access and memory corruption.
Add a sanity check before processing the SKB to prevent invalid
data access in the undecap native Wi-Fi function for the
DP_RX_DECAP_TYPE_NATIVE_WIFI decap type.
Tested-on: QCN9274 hw2.0 PCI WLAN.WBE.1.3.1-00173-QCAHKSWPL_SILICONZ-1 |
| Improper Handling of Exceptional Conditions vulnerability in Erlang OTP erts (epmd) allows an unauthenticated remote attacker to permanently terminate the Erlang Port Mapper Daemon (epmd) via connection slot exhaustion.
The do_accept function in erts/epmd/src/epmd_srv.c calls epmd_cleanup_exit() when accept(2) returns EMFILE (per-process file descriptor limit reached) or ENFILE (system-wide file descriptor limit reached), rather than treating these as recoverable conditions. An attacker can exhaust epmd's file descriptor slots by holding many TCP connections open while periodically sending a single byte to reset the idle timeout, then causing accept(2) to return EMFILE, which kills the daemon. epmd has no per-source-IP connection cap, making the attack feasible from a single source.
On Debian/Ubuntu default packaging the impact is amplified: the systemd unit inherits a low file descriptor soft limit, and repeated daemon deaths trigger systemd's start-rate-limit, permanently failing both epmd.service and epmd.socket and requiring manual operator intervention to recover.
This issue affects OTP from OTP 17.0 before OTP 29.0.4, OTP 28.5.0.4 and OTP 27.3.4.15. |
| In the Linux kernel, the following vulnerability has been resolved:
net: phonet: do not BUG_ON() in pn_socket_autobind() on failed bind
syzbot reported a kernel BUG triggered from pn_socket_sendmsg() via
pn_socket_autobind():
kernel BUG at net/phonet/socket.c:213!
RIP: 0010:pn_socket_autobind net/phonet/socket.c:213 [inline]
RIP: 0010:pn_socket_sendmsg+0x240/0x250 net/phonet/socket.c:421
Call Trace:
sock_sendmsg_nosec+0x112/0x150 net/socket.c:797
__sock_sendmsg net/socket.c:812 [inline]
__sys_sendto+0x402/0x590 net/socket.c:2280
...
pn_socket_autobind() calls pn_socket_bind() with port 0 and, on
-EINVAL, assumes the socket was already bound and asserts that the
port is non-zero:
err = pn_socket_bind(sock, ..., sizeof(struct sockaddr_pn));
if (err != -EINVAL)
return err;
BUG_ON(!pn_port(pn_sk(sock->sk)->sobject));
return 0; /* socket was already bound */
However pn_socket_bind() also returns -EINVAL when sk->sk_state is not
TCP_CLOSE, even when the socket has never been bound and pn_port() is
still 0. In that case the BUG_ON() fires and panics the kernel from a
user-triggerable path.
Treat the "bind returned -EINVAL but pn_port() is still 0" case as a
regular error and propagate -EINVAL to the caller instead of crashing.
Existing callers already translate a non-zero return from
pn_socket_autobind() into -ENOBUFS/-EAGAIN, so returning -EINVAL here
only changes behaviour from panic to a normal errno. |
| In the Linux kernel, the following vulnerability has been resolved:
ovl: keep err zero after successful ovl_cache_get()
ovl_iterate_merged() stores PTR_ERR(cache) in err before checking
IS_ERR(cache). On success err holds the truncated cache pointer and
can be returned as a bogus non-zero error.
The syzbot reproducer reaches this through overlay-on-overlay readdir:
getdents64
iterate_dir(outer overlay file)
ovl_iterate_merged()
ovl_cache_get()
ovl_dir_read_merged()
ovl_dir_read()
iterate_dir(inner overlay file)
ovl_iterate_merged()
Only compute PTR_ERR(cache) on the error path. |
| In the Linux kernel, the following vulnerability has been resolved:
drm/vc4: fix krealloc() memory leak
Don't just overwrite the original pointer passed to krealloc()
with its return value without checking latter:
MEM = krealloc(MEM, SZ, GFP);
If krealloc() returns NULL, that erases the pointer
to the still allocated memory, hence leaks this memory.
Instead, use a temporary variable, check it's not NULL
and only then assign it to the original pointer:
TMP = krealloc(MEM, SZ, GFP);
if (!TMP) return;
MEM = TMP;
While on it, use krealloc_array(). |
| Incorrect check of function return value in Caliptra Core Runtime Firmware (ActivateFirmwareCmd::activate_fw modules) allows bypass of Caliptra Core's verification of the MCU FW during a hitless update.
This issue affects Core Runtime Firmware: from 2.0.0 through 2.0.1, 2.1.0. |
| In the Linux kernel, the following vulnerability has been resolved:
rxrpc: Fix error handling in rxgk_extract_token()
Fix a missing bit of error handling in rxgk_extract_token(): in the event
that rxgk_decrypt_skb() returns -ENOMEM, it should just return that rather
than continuing on (for anything else, it generates an abort). |
| ImageMagick is free and open-source software used for editing and manipulating digital images. Prior to versions 6.9.13-48 and 7.1.2-24, a missing check of a return value could lead to a heap buffer over-write in the MAT decoder on 32-bit systems. This issue has been patched in versions 6.9.13-48 and 7.1.2-24. |
| Windows Hyper-V Denial of Service Vulnerability |
| In the Linux kernel, the following vulnerability has been resolved:
ipv4: icmp: fix null-ptr-deref in icmp_build_probe()
ipv6_stub->ipv6_dev_find() may return ERR_PTR(-EAFNOSUPPORT) when the
IPv6 stack is not active (CONFIG_IPV6=m and not loaded), and passing
this error pointer to dev_hold() will cause a kernel crash with
null-ptr-deref.
Instead, silently discard the request. RFC 8335 does not appear to
define a specific response for the case where an IPv6 interface
identifier is syntactically valid but the implementation cannot perform
the lookup at runtime, and silently dropping the request may safer than
misreporting "No Such Interface". |
| A flaw was found in Corosync. A remote unauthenticated attacker can exploit a wrong return value vulnerability in the Corosync membership commit token sanity check by sending a specially crafted User Datagram Protocol (UDP) packet. This can lead to an out-of-bounds read, causing a denial of service (DoS) and potentially disclosing limited memory contents |
| In the Linux kernel, the following vulnerability has been resolved:
kprobes: avoid crash when rmmod/insmod after ftrace killed
After we hit ftrace is killed by some errors, the kernel crash if
we remove modules in which kprobe probes.
BUG: unable to handle page fault for address: fffffbfff805000d
PGD 817fcc067 P4D 817fcc067 PUD 817fc8067 PMD 101555067 PTE 0
Oops: Oops: 0000 [#1] SMP KASAN PTI
CPU: 4 UID: 0 PID: 2012 Comm: rmmod Tainted: G W OE
Tainted: [W]=WARN, [O]=OOT_MODULE, [E]=UNSIGNED_MODULE
RIP: 0010:kprobes_module_callback+0x89/0x790
RSP: 0018:ffff88812e157d30 EFLAGS: 00010a02
RAX: 1ffffffff805000d RBX: dffffc0000000000 RCX: ffffffff86a8de90
RDX: ffffed1025c2af9b RSI: 0000000000000008 RDI: ffffffffc0280068
RBP: 0000000000000000 R08: 0000000000000001 R09: ffffed1025c2af9a
R10: ffff88812e157cd7 R11: 205d323130325420 R12: 0000000000000002
R13: ffffffffc0290488 R14: 0000000000000002 R15: ffffffffc0280040
FS: 00007fbc450dd740(0000) GS:ffff888420331000(0000) knlGS:0000000000000000
CS: 0010 DS: 0000 ES: 0000 CR0: 0000000080050033
CR2: fffffbfff805000d CR3: 000000010f624000 CR4: 00000000000006f0
Call Trace:
<TASK>
notifier_call_chain+0xc6/0x280
blocking_notifier_call_chain+0x60/0x90
__do_sys_delete_module.constprop.0+0x32a/0x4e0
do_syscall_64+0x5d/0xfa0
entry_SYSCALL_64_after_hwframe+0x76/0x7e
This is because the kprobe on ftrace does not correctly handles
the kprobe_ftrace_disabled flag set by ftrace_kill().
To prevent this error, check kprobe_ftrace_disabled in
__disarm_kprobe_ftrace() and skip all ftrace related operations. |
| Yubico webauthn-server-core (aka java-webauthn-server) 2.8.0 before 2.8.2 incorrectly checks a function's return value in the second factor flow, leading to impersonation. |
| A security flaw has been discovered in GNU Binutils 2.45. Impacted is the function tg_tag_type of the file prdbg.c. Performing a manipulation results in unchecked return value. The attack needs to be approached locally. The exploit has been released to the public and may be used for attacks. |
| In the Linux kernel, the following vulnerability has been resolved:
drm/tegra: Fix NULL vs IS_ERR() check in probe()
The iommu_paging_domain_alloc() function doesn't return NULL pointers,
it returns error pointers. Update the check to match. |
| In the Linux kernel, the following vulnerability has been resolved:
pstore: ram_core: fix incorrect success return when vmap() fails
In persistent_ram_vmap(), vmap() may return NULL on failure.
If offset is non-zero, adding offset_in_page(start) causes the function
to return a non-NULL pointer even though the mapping failed.
persistent_ram_buffer_map() therefore incorrectly returns success.
Subsequent access to prz->buffer may dereference an invalid address
and cause crashes.
Add proper NULL checking for vmap() failures. |
| In the Linux kernel, the following vulnerability has been resolved:
gpio: qixis-fpga: Fix error handling for devm_regmap_init_mmio()
devm_regmap_init_mmio() returns an ERR_PTR() on failure, not NULL.
The original code checked for NULL which would never trigger on error,
potentially leading to an invalid pointer dereference.
Use IS_ERR() and PTR_ERR() to properly handle the error case. |
| mutt before 2.3.2 has an infinite loop in data_object_to_stream in crypt-gpgme.c. |
| The recursive mode (-R) of the chmod utility in uutils coreutils incorrectly handles exit codes when processing multiple files. The final return value is determined solely by the success or failure of the last file processed. This allows the command to return an exit code of 0 (success) even if errors were encountered on previous files, such as 'Operation not permitted'. Scripts relying on these exit codes may proceed under a false sense of success while sensitive files remain with restrictive or incorrect permissions. |
| A flaw in the ChownExecutor used by uutils coreutils chown and chgrp causes the utilities to return an incorrect exit code during recursive operations. The final exit code is determined only by the last file processed. If the last operation succeeds, the command returns 0 even if earlier ownership or group changes failed due to permission errors. This can lead to security misconfigurations where administrative scripts incorrectly assume that ownership has been successfully transferred across a directory tree. |
