| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| In the Linux kernel, the following vulnerability has been resolved:
firewire: ohci: mask bus reset interrupts between ISR and bottom half
In the FireWire OHCI interrupt handler, if a bus reset interrupt has
occurred, mask bus reset interrupts until bus_reset_work has serviced and
cleared the interrupt.
Normally, we always leave bus reset interrupts masked. We infer the bus
reset from the self-ID interrupt that happens shortly thereafter. A
scenario where we unmask bus reset interrupts was introduced in 2008 in
a007bb857e0b26f5d8b73c2ff90782d9c0972620: If
OHCI_PARAM_DEBUG_BUSRESETS (8) is set in the debug parameter bitmask, we
will unmask bus reset interrupts so we can log them.
irq_handler logs the bus reset interrupt. However, we can't clear the bus
reset event flag in irq_handler, because we won't service the event until
later. irq_handler exits with the event flag still set. If the
corresponding interrupt is still unmasked, the first bus reset will
usually freeze the system due to irq_handler being called again each
time it exits. This freeze can be reproduced by loading firewire_ohci
with "modprobe firewire_ohci debug=-1" (to enable all debugging output).
Apparently there are also some cases where bus_reset_work will get called
soon enough to clear the event, and operation will continue normally.
This freeze was first reported a few months after a007bb85 was committed,
but until now it was never fixed. The debug level could safely be set
to -1 through sysfs after the module was loaded, but this would be
ineffectual in logging bus reset interrupts since they were only
unmasked during initialization.
irq_handler will now leave the event flag set but mask bus reset
interrupts, so irq_handler won't be called again and there will be no
freeze. If OHCI_PARAM_DEBUG_BUSRESETS is enabled, bus_reset_work will
unmask the interrupt after servicing the event, so future interrupts
will be caught as desired.
As a side effect to this change, OHCI_PARAM_DEBUG_BUSRESETS can now be
enabled through sysfs in addition to during initial module loading.
However, when enabled through sysfs, logging of bus reset interrupts will
be effective only starting with the second bus reset, after
bus_reset_work has executed. |
| In the Linux kernel, the following vulnerability has been resolved:
fs/9p: only translate RWX permissions for plain 9P2000
Garbage in plain 9P2000's perm bits is allowed through, which causes it
to be able to set (among others) the suid bit. This was presumably not
the intent since the unix extended bits are handled explicitly and
conditionally on .u. |
| An overly-permissive IAM trust policy in the Harmonix on AWS framework may allow IAM principals in the same AWS account to escalate privileges via role assumption. The sample code for the EKS environment provisioning role is configured to trust the account root principal, which may enable any IAM principal in the same AWS account with sts:AssumeRole permissions to assume the role with administrative privileges.
We recommend customers upgrade to Harmonix on AWS v0.4.2 or later if you have deployed the framework using versions v0.3.0 through v0.4.1. |
| GitLab has remediated an issue in GitLab CE/EE affecting all versions from 15.6 before 18.4.6, 18.5 before 18.5.4, and 18.6 before 18.6.2 that could have allowed an authenticated user to, under certain conditions, render content in dialogs to other users by injecting malicious HTML content into merge request titles. |
| A remote code execution vulnerability exists within multiple subsystems of Drupal 7.x and 8.x. This potentially allows attackers to exploit multiple attack vectors on a Drupal site, which could result in the site being compromised. This vulnerability is related to Drupal core - Highly critical - Remote Code Execution - SA-CORE-2018-002. Both SA-CORE-2018-002 and this vulnerability are being exploited in the wild. |
| SIPGO is a library for writing SIP services in the GO language. Starting in version 0.3.0 and prior to version 1.0.0-alpha-1, a nil pointer dereference vulnerability is in the SIPGO library's `NewResponseFromRequest` function that affects all normal SIP operations. The vulnerability allows remote attackers to crash any SIP application by sending a single malformed SIP request without a To header. The vulnerability occurs when SIP message parsing succeeds for a request missing the To header, but the response creation code assumes the To header exists without proper nil checks. This affects routine operations like call setup, authentication, and message handling - not just error cases. This vulnerability affects all SIP applications using the sipgo library, not just specific configurations or edge cases, as long as they make use of the `NewResponseFromRequest` function. Version 1.0.0-alpha-1 contains a patch for the issue. |
| A vulnerability in Apache Airflow allowed authenticated UI users to view secret values in rendered templates due to secrets not being properly redacted, potentially exposing secrets to users without the appropriate authorization.
Users are recommended to upgrade to version 3.1.4, which fixes this issue. |
| Missing Authorization vulnerability in merkulove Coder for Elementor coder-elementor allows Exploiting Incorrectly Configured Access Control Security Levels.This issue affects Coder for Elementor: from n/a through <= 1.0.13. |
| Missing Authorization vulnerability in etruel WP Views Counter wpecounter allows Exploiting Incorrectly Configured Access Control Security Levels.This issue affects WP Views Counter: from n/a through <= 2.1.2. |
| The issue was addressed with improved checks. This issue is fixed in macOS Tahoe 26.1. An app may be able to access sensitive user data. |
| A logic issue was addressed with improved restrictions. This issue is fixed in macOS Tahoe 26.1. An app may be able to access sensitive user data. |
| Voluntarily withdrawn |
| Spip 4.1.10 contains a file upload vulnerability that allows attackers to upload malicious SVG files with embedded external links. Attackers can trick administrators into clicking a crafted SVG logo that redirects to a potentially dangerous URL through improper file upload filtering. |
| WebsiteBaker 2.13.3 contains a stored cross-site scripting vulnerability that allows authenticated users to upload malicious SVG files with embedded JavaScript. Attackers can upload crafted SVG files with script tags that execute when the file is viewed, enabling persistent cross-site scripting attacks. |
| WebsiteBaker 2.13.3 contains a directory traversal vulnerability that allows authenticated attackers to delete arbitrary files by manipulating directory path parameters. Attackers can send crafted GET requests to /admin/media/delete.php with directory traversal sequences to delete files outside the intended directory. |
| WBCE CMS 1.6.1 contains a cross-site scripting vulnerability that allows attackers to inject malicious HTML and CSS to capture user keystrokes. Attackers can upload a crafted HTML file with CSS-based keylogging techniques to intercept password characters through background image requests. |
| PodcastGenerator 3.2.9 contains a blind server-side request forgery vulnerability that allows attackers to inject XML in the episode upload form. Attackers can manipulate the 'shortdesc' parameter to trigger external HTTP requests to arbitrary endpoints during podcast episode creation. |
| Rukovoditel 3.4.1 contains multiple stored cross-site scripting vulnerabilities that allow authenticated attackers to inject malicious scripts. Attackers can insert XSS payloads in project task comments to execute arbitrary JavaScript in victim browsers. |
| tRPC allows users to build and consume fully typesafe APIs without schemas or code generation. Starting in version 10.27.0 and prior to versions 10.45.3 and 11.8.0, a A prototype pollution vulnerability exists in `@trpc/server`'s `formDataToObject` function, which is used by the Next.js App Router adapter. An attacker can pollute `Object.prototype` by submitting specially crafted FormData field names, potentially leading to authorization bypass, denial of service, or other security impacts. Note that this vulnerability is only present when using `experimental_caller` / `experimental_nextAppDirCaller`. Versions 10.45.3 and 11.8.0 fix the issue. |
| In JetBrains TeamCity before 2025.11.1 reflected XSS was possible on the storage settings page |
