| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| In Zephyr's experimental USB host stack (CONFIG_USB_HOST_STACK), usbh_device_disconnect() (subsys/usb/host/usbh_device.c) freed the root usb_device slab object without clearing the cached pointer ctx->root. The bus removal handler dev_removed_handler() (subsys/usb/host/usbh_core.c) decides what to tear down solely from ctx->root, checking only that it is non-NULL.
Because UHC controller drivers (e.g. uhc_max3421e, uhc_mcux_common) synthesize UHC_EVT_DEV_REMOVED directly from physical bus line state with no debounce or state guard, an attacker with physical USB access (or a rogue device that bounces its connection) can deliver a second device-removed event after a root device disconnect. The handler then re-enters usbh_device_disconnect() with the dangling pointer, locking a mutex inside the freed object (use-after-free), removing the freed node from the device list, and calling k_mem_slab_free() on the already-freed block (double-free). If the slab block has been reissued to a newly attached device in between, this corrupts a live object.
Impact is denial of service (crash) and memory corruption; the attack vector is physical/local. The flaw was introduced in v4.4.0 by the connect/disconnect refactor and is fixed by clearing ctx->root in usbh_device_disconnect() before freeing. |
| The nRF70 Wi-Fi driver's power-save event handler nrf_wifi_event_proc_get_power_save_info() in drivers/wifi/nrf_wifi/src/wifi_mgmt.c copied TWT (Target Wake Time) flow entries from an nrf_wifi_umac_event_power_save_info event into the fixed-size twt_flows[WIFI_MAX_TWT_FLOWS] (8-element) array of a caller-supplied struct wifi_ps_config, looping over event-provided num_twt_flows without validating it against WIFI_MAX_TWT_FLOWS or checking event_len. When num_twt_flows exceeds 8, the handler writes past the destination array (which is typically on the caller's stack, e.g. the wifi ps shell command) -- an out-of-bounds write of ~40-byte TWT entries -- and reads twt_flow_info[i] past the event buffer. The event is delivered by the nRF70 co-processor firmware in response to a host-initiated power-save GET, so reaching the overflow requires the firmware to emit a malformed or out-of-range event; the trust boundary is host-to-trusted-coprocessor rather than a direct remote-AP write, with over-the-air influence on the flow count being indirect and bounded by the 3-bit TWT flow-id space. Affected: builds with CONFIG_NRF70_STA_MODE on releases through v4.4.0. The fix rejects events with num_twt_flows > WIFI_MAX_TWT_FLOWS or with event_len shorter than the claimed entries, and adds a NULL check on the caller buffer. |
| parse_ipv4() in subsys/net/ip/utils.c (reached via net_ipaddr_parse() for strings of the form "a.b.c.d:port") copies the port substring into a fixed 17-byte stack buffer (char ipaddr[NET_IPV4_ADDR_LEN + 1]) using a length of str_len - end - 1, where str_len is the full, unbounded input length and end is only the (<=15-byte) offset of the ':' delimiter. Because the destination size is never consulted, a crafted address string with a long suffix after the colon (e.g. "1.2.3.4:" followed by hundreds of bytes) causes an out-of-bounds stack write whose length and contents are fully attacker-controlled (memcpy of the suffix plus a trailing NUL), enabling memory corruption and at minimum a denial of service, and potentially control-flow hijack. The parser is reached from the standard socket API (zsock_getaddrinfo / literal-address resolution), DNS server-string configuration, and the eswifi Wi-Fi co-processor DNS-response path, so an application that resolves a network-influenced address string is exposed. The bug was introduced when the parser was added (Zephyr v1.9.0) and shipped in all releases through v4.4.0. The fix removes the unbounded copy and validates the port length before copying into a small dedicated buffer. Note: the equivalent IPv6 "[addr]:port" path in parse_ipv6() retains the same unbounded copy at this commit and remains a separate, still-reachable instance of the defect. |
| Zephyr's dynamic kernel-object tracking (kernel/userspace/userspace.c, formerly kernel/userspace.c) maintains a doubly-linked list (obj_list) of dynamically allocated kernel objects. Iteration over this list in k_object_wordlist_foreach() was performed under lists_lock using the SAFE iterator (which caches the next node), but list removal and freeing of nodes was performed under different, disjoint spinlocks: objfree_lock in k_object_free() and obj_lock in unref_check(). On an SMP system, while one CPU iterated obj_list under lists_lock, another CPU could unlink and k_free() the dyn_obj node that the iterator had cached as its next pointer, causing the iterator to dereference freed kernel memory (use-after-free / dangling list traversal). All of the racing operations are reachable from unprivileged user-mode threads via system calls: k_object_alloc/k_object_alloc_size and k_object_release drive removals through unref_check() (under obj_lock), while k_thread_abort and thread creation drive the iteration through k_thread_perms_all_clear()/k_thread_perms_inherit() (under lists_lock). A deprivileged user thread on a CONFIG_SMP + CONFIG_USERSPACE build can therefore corrupt the kernel's object-tracking structures across the userspace security boundary, yielding kernel memory corruption (potential privilege escalation) or a kernel crash (denial of service). The fix removes objfree_lock and serializes every obj_list modification under lists_lock, including holding it across find+remove in k_object_free() and around unref_check() in k_thread_perms_clear(). Affects CONFIG_SMP+CONFIG_USERSPACE+CONFIG_DYNAMIC_OBJECTS configurations; the defect dates to the 2019 spinlockification (commit 8a3d57b6cc6, first released in v1.14.0) and shipped through v4.4.0. |
| The Nuvoton NuMaker HSUSBD USB device-controller driver (drivers/usb/udc/udc_numaker.c) armed the control Data IN stage unconditionally (base->CEPTXCNT = len in numaker_hsusbd_ep_trigger). Because the HSUSBD hardware cannot disarm a control Data IN already armed for a previous transfer, a USB host that cancels an in-flight control transfer (timeout) and then issues a new SETUP packet can drive the driver out of sync: stale data may be transmitted in the new transfer and the control endpoint can become permanently stuck NAK'ing every subsequent control transfer.
A malicious or buggy host (physical/adjacent attacker driving the bus) can repeatedly cancel-and-re-SETUP to wedge the device's USB control endpoint, denying service to the device's USB function (the device stops enumerating/responding on the control pipe) until a USB reset or re-plug. The flaw is an availability-only denial of service; the FIFO copy loops (bounded by net_buf length and the hardware BUFFULL flag) and the net_buf lifecycle are independent of the arming desync, so there is no out-of-bounds access, use-after-free, or information leak.
The fix monitors the IN-token and new-SETUP events (k_event) and only arms control Data IN when an IN token is present and no new SETUP has arrived, cancelling the current transfer on a new SETUP. Affects boards using the Nuvoton NuMaker HSUSBD controller (CONFIG_UDC_NUMAKER with DT_HAS_NUVOTON_NUMAKER_HSUSBD_ENABLED); shipped in v4.4.0. |
| mrubyc through 3.4.1 was found to contain a NULL pointer dereference in src/vm.c in op_super() / OP_SUPER due to a missing runtime guard for top-level super. |
| The AllCoach WordPress plugin before 1.0.2 does not verify that an email address submitted to a public account-registration endpoint is not already associated with an existing user before overwriting that user's password, allowing unauthenticated attackers to reset the password of arbitrary accounts, including administrators, and take over the site. |
| The FileOrganizer WordPress plugin before 1.1.9, Advanced File Manager WordPress plugin before 5.4.12, File Manager Pro WordPress plugin before 2.1.1, File Manager WordPress plugin before 8.0.4 do not properly escape a parameter before passing it to a shell command when processing image operations, allowing authenticated users to perform OS Command Injection. This requires the server to have the ImageMagick convert CLI available without either the PHP imagick or GD extensions. |
| A NULL pointer dereference in smooth_parse_stream_index() in src/media_tools/mpd.c in GPAC master HEAD before commit b35c61f104b85fbb16520ac2838d5d2ef70845b5 allows attackers to cause a denial of service |
| An out-of-bounds read vulnerability exists in FreeType 2.14.3 and versions before commit 5a280ecde6f324de0d226261036e736e0cb49a71 in src/truetype/ttgxvar.c, in the TT_Get_Var_Design implementation used by FT_Get_Var_Design_Coordinates |
| Uncaught Exception (CWE-248) in the T20 Readers allows an authenticated and authorized operator to trigger a restart by sending specific requests, resulting in a temporary denial of service. Version of Command Centre affected:
* 9.50 prior to vCR9.50.260616a (distributed in 9.50.1587(MR1))
* 9.40 prior to vCR9.40.260616a (distributed in 9.40.3130(MR3))
* 9.30 prior to vCR9.30.260616a (distributed in 9.30.3983(MR5))
* 9.20 prior to vCR9.20.260616a (distributed in 9.20.4349(MR7))
* all versions of 9.10 and prior. |
| MicroRealEstate is affected by broken object-level access controls in PDF generator functionality.
This issue affects MicroRealEstate: through 1.0.0-alpha3. |
| Cross-site request forgery vulnerability exists in SEIKO EPSON Web Config. If a user views a malicious page while logged into Web Config, unintended operations may be performed. |
| Dell PowerProtect Data Domain, versions 7.7.1.0 through 8.7, LTS2026 release version 8.6.1.0 through 8.6.1.10, LTS2025 release version 8.3.1.0 through 8.3.1.30, LTS2024 release versions 7.13.1.0 through 7.13.1.70 an improper authentication vulnerability. An unauthenticated attacker with remote access could potentially exploit this vulnerability, leading to unauthorized access. This is a critical severity vulnerability as it allows an attacker to take complete control of system; so Dell recommends customers to upgrade at the earliest opportunity. |
| Dell PowerProtect Data Domain, versions 7.7.1.0 through 8.7, LTS2026 release version 8.6.1.0 through 8.6.1.10, LTS2025 release version 8.3.1.0 through 8.3.1.30, LTS2024 release versions 7.13.1.0 through 7.13.1.70 contain an improper limitation of a pathname to a restricted directory ('Path Traversal') vulnerability. An unauthenticated attacker with remote access could potentially exploit this vulnerability, leading to unauthorized access to the system. This is a critical severity vulnerability as it allows an attacker to take complete control of system; so Dell recommends customers to upgrade at the earliest opportunity. |
| Untrusted pointer dereference in Microsoft Edge (Chromium-based) allows an unauthorized attacker to elevate privileges over a network. |
| A SQL injection vulnerability in SOGo before 5.12.7 allows authenticated users to execute arbitrary SQL statements via the search parameter of the allContactSearch endpoint. |
| An issue in SQLite before Fossil check-in 869a51ae84df allows a local attacker to obtain sensitive information via the Session Extension changeset concat/changegroup merge path |
| An OS command injection vulnerability exists in the start_bonjour() function of the "rc" binary in Cisco RV130/RV130W with firmware 1.0.3.55 and RV110W routers with firmware 1.2.2.5 / 1.2.2.8. The wan_hostname configuration parameter is not properly sanitized, which could allow an authenticated remote attacker to execute arbitrary OS commands with root privileges. |
| An OS command injection vulnerability exists in the save_syslog_to_file() function of the "httpd" binary in Cisco RV130/RV130W with firmware 1.0.3.55 and RV110W routers with firmware 1.2.2.5 / 1.2.2.8. The model_name configuration parameter is not properly sanitized, which could allow an authenticated remote attacker to execute arbitrary OS commands with root privileges. |
