| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| IBM Security Verify Access 10.0 through 10.0.9.2 and IBM Verify Identity Access 11.0 through 11.0.3 and IBM Verify Identity Access Container 11.0 through 11.0.3 and IBM Security Verify Access Container 10.0 through 10.0.9.2 Reverse Proxy in certain configurations is vulnerable to a denial of service attack. |
| The Zephyr ADIN2111/ADIN1110 10BASE-T1S/T1L Ethernet driver (drivers/ethernet/eth_adin2111.c) reassembles received Ethernet frames in OPEN Alliance (OA) SPI mode by copying device-supplied 64-byte data chunks into a fixed static buffer ctx->buf of size CONFIG_ETH_ADIN2111_BUFFER_SIZE (default 1524 bytes). In eth_adin2111_oa_data_read(), each valid chunk was memcpy'd into ctx->buf[ctx->scur] and the write cursor scur advanced, with no check that scur + len stayed within the buffer. The number of chunks (up to 255, from the BUFSTS RCA field) and the per-chunk length are taken entirely from the frame data received off the wire; the cursor is only reset on a start-of-frame chunk. An attacker on the single-pair Ethernet segment can therefore send a frame whose reassembled size exceeds the configured buffer, causing the driver's RX offload thread to write attacker-controlled frame bytes past the end of the static buffer into adjacent driver/kernel memory (up to roughly 14.8 KB in the worst case). This is a remotely/adjacently reachable out-of-bounds write (CWE-787) that can corrupt memory and cause denial of service or potentially code execution. The defect was introduced when OA SPI support was added (commit 0ca8b0756b1) and shipped in releases v3.7.0 through v4.4.0. The fix adds a bounds check that drops the oversized frame and resets the cursor before the copy. |
| IBM Security Verify Access 10.0 through 10.0.9.2 and IBM Verify Identity Access 11.0 through 11.0.3 and IBM Verify Identity Access Container 11.0 through 11.0.3 Reverse Proxy in certain configurations may provide weaker than expected cryptographic validation of user supplied data. |
| IBM Planning Analytics 2.0, and 2.1 Local is vulnerable to cross-site request forgery which could allow an attacker to execute malicious and unauthorized actions transmitted from a user that the website trusts. |
| IBM WebSphere Application Server - Liberty 17.0.0.3 through 26.0.0.8 is vulnerable to a privilege escalation when using Liberty collectives. |
| A time-of-check to time-of-use (TOCTOU) race condition in the installation and uninstallation process of certain Zoom Clients for Windows could allow an authenticated local user to escalate privileges. |
| In the Linux kernel, the following vulnerability has been resolved:
netfilter: xt_u32: reject invalid shift counts
u32_match_it() executes rule-supplied shift operands on a 32-bit
value. A malformed u32 rule can provide a shift count of 32 or more,
triggering an undefined shift out-of-bounds during packet evaluation.
Validate XT_U32_LEFTSH and XT_U32_RIGHTSH operands in
u32_mt_checkentry() and reject malformed rules before they reach the
packet path. |
| In the Linux kernel, the following vulnerability has been resolved:
ice: fix FDIR CTRL VSI resource leak in ice_reset_all_vfs()
Resetting all VFs causes resource leak on VFs with FDIR filters
enabled as CTRL VSIs are only invalidated and not freed. Fix by using
ice_vf_ctrl_vsi_release() instead of ice_vf_ctrl_invalidate_vsi() which
aligns behavior with the ice_reset_vf() function.
Reproduction:
echo 1 > /sys/class/net/$pf/device/sriov_numvfs
ethtool -N $vf flow-type ether proto 0x9000 action 0
echo 1 > /sys/class/net/$pf/device/reset |
| New API is a large language mode (LLM) gateway and artificial intelligence (AI) asset management system. Prior to 1.0.0-rc.11, POST /api/stripe/webhook, POST /api/creem/webhook, and POST /api/waffo/webhook read and log full request bodies before signature validation in router/api-router.go and the payment controllers, allowing an unauthenticated attacker to cause memory pressure, container restarts, or disk exhaustion without forging a successful payment. This issue is fixed in version 1.0.0-rc.11. |
| websocket-driver is a WebSocket protocol handler with pluggable I/O. Prior to 0.8.2, WebSocket::Driver.server() passes a malformed Host header to URI.parse in lib/websocket/http/request.rb without catching URI::InvalidURIError, allowing a remote client to crash a TCP-backed WebSocket server when the application does not catch the error from parse(). This issue is fixed in version 0.8.2. |
| The ARM PL011 UART driver in drivers/serial/uart_pl011.c fails to acknowledge receive error interrupts. On the PL011, the framing, parity, break, and overrun error interrupts (PL011_IMSC_ERROR_MASK) are cleared only by writing the interrupt-clear register UARTICR; reading the data register clears the RX interrupt and the per-byte RSR status but not the error interrupt status in MIS. The interrupt service routine pl011_isr() acknowledged only the CTS modem-status interrupt and never wrote icr for the error bits, so an asserted error interrupt remains pending after the ISR returns.
When an application enables error-interrupt reporting via the public uart_irq_err_enable() API, an attacker who controls the serial peer can deterministically assert these error bits by injecting line errors on the RX line — a baud/stop-bit mismatch or mid-character break (framing/break error), a flipped parity bit (parity error), or FIFO flooding (overrun error). Because the error interrupt is never cleared, the interrupt line stays asserted and the CPU re-enters pl011_isr() immediately and indefinitely, producing an interrupt-storm livelock from which the core makes no forward progress.
The impact is an availability-only denial of service (permanent hang), reachable from an external or removable UART peer. Exploitation is gated by configuration: the error interrupt is off by default and no in-tree subsystem enables it, so only applications that explicitly call uart_irq_err_enable() on a PL011-based, interrupt-driven port are affected. The fix makes pl011_isr() acknowledge the pending error bits via uart->icr, breaking the loop, and additionally clears the latched RSR status in pl011_err_check(). |
| TLS hostname verification issue in Apache Ranger Client Code in versions <= 2.8.0.
Users are recommended to upgrade to version 2.9.0, which fixes this issue. |
| Improper Privilege Management in Zoom Rooms for Windows before version 7.1.0 may allow an authenticated user to conduct an escalation of privilege via local access. |
| IBM Db2 12.1.5 for Linux, UNIX and Windows (includes DB2 Connect Server) could allow a local attacker to cause a denial of service due to a memory leak. |
| IBM Security Verify Access 10.0 through 10.0.9.2 and IBM Verify Identity Access 11.0 through 11.0.3 and IBM Verify Identity Access Container 11.0 through 11.0.3 Reverse Proxy in certain configurations may provide weaker than expected cryptographic validation of user supplied data. |
| In the Linux kernel, the following vulnerability has been resolved:
pds_core: fix error handling in pdsc_devcmd_wait
Fix two cases where pdsc_devcmd_wait() returns stale success from
the completion register instead of an error:
1. FW crash: If firmware stops running, the wait loop breaks early with
running=false. The condition "if ((!done || timeout) && running)" is
false, so error handling is bypassed and stale status is returned.
Check !running first and return -ENXIO.
2. Timeout: If a command times out, err is set to -ETIMEDOUT but then
overwritten by pdsc_err_to_errno(status) which reads stale status.
Return -ETIMEDOUT immediately after cleaning up.
Both errors now propagate to pdsc_devcmd_locked() which queues
health_work for recovery. |
| Path Traversal and Unrestricted File Upload exists in the Ninja Forms plugin before 3.0.23 for WordPress (when the Uploads add-on is activated). This allows an attacker to traverse the file system to access files and execute code via the includes/fields/upload.php (aka upload/submit page) name and tmp_name parameters. |
| In the Linux kernel, the following vulnerability has been resolved:
dma-mapping: move dma_map_resource() sanity check into debug code
dma_map_resource() uses pfn_valid() to ensure the range is not RAM.
However, pfn_valid() only checks for availability of the memory map for
a PFN but it does not ensure that the PFN is actually backed by RAM. On
ARM64 with SPARSEMEM (128MB section granularity), MMIO addresses that
share a section with RAM will falsely trigger the WARN_ON_ONCE and cause
dma_map_resource() to return DMA_MAPPING_ERROR.
This causes a WARNING on Raspberry Pi 4 during spi_bcm2835 probe because
the SPI FIFO register (0xfe204004) falls in the same sparsemem section
as the end of RAM (0xf8000000-0xfbffffff), both in section 31
(0xf8000000-0xffffffff).
Move the sanity check from dma_map_resource() into debug_dma_map_phys()
and replace the unreliable pfn_valid() with pfn_valid() &&
!PageReserved(), which correctly identifies actual usable RAM without
false positives for MMIO regions that happen to have struct pages.
Since dma_map_resource() is dma_map_phys(DMA_ATTR_MMIO), the check
applies equally to both APIs. Any non-reserved page represents kernel
memory to a sufficient degree that using DMA_ATTR_MMIO on it is almost
certainly wrong and risks breaking coherency on non-coherent platforms.
ZONE_DEVICE pages used for PCI P2P DMA (MEMORY_DEVICE_PCI_P2PDMA) have
PageReserved set, so they will not trigger a false positive.
The check no longer blocks the mapping and uses err_printk() to
integrate with dma-debug filtering. |
| Scriban before 6.6.0 contains an infinite recursion vulnerability in object rendering when the ObjectRecursionLimit property defaults to unlimited. Attackers can supply circular reference objects to the template context, exhausting stack space and triggering an uncatchable StackOverflowException that terminates the hosting process. |
| Scriban before 7.0.0 (affected versions <= 6.6.0) contains an uncontrolled memory allocation vulnerability in the string.pad_left and string.pad_right template functions, which perform no validation on the width parameter before delegating to .NET's String.PadLeft/PadRight. When an application exposes Scriban to untrusted template input, an attacker can supply an arbitrarily large width value (e.g., 500,000,000) to trigger ~1GB memory allocations in a single call, resulting in OutOfMemoryException and denial of service. The TemplateContext.LimitToString limit does not prevent this because it is only enforced after the string has been fully allocated. |
