| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| In the Linux kernel, the following vulnerability has been resolved:
gfs2: Fix use-after-free in iomap inline data write path
The inline data buffer head (dibh) is being released prematurely in
gfs2_iomap_begin() via release_metapath() while iomap->inline_data
still points to dibh->b_data. This causes a use-after-free when
iomap_write_end_inline() later attempts to write to the inline data
area.
The bug sequence:
1. gfs2_iomap_begin() calls gfs2_meta_inode_buffer() to read inode
metadata into dibh
2. Sets iomap->inline_data = dibh->b_data + sizeof(struct gfs2_dinode)
3. Calls release_metapath() which calls brelse(dibh), dropping refcount
to 0
4. kswapd reclaims the page (~39ms later in the syzbot report)
5. iomap_write_end_inline() tries to memcpy() to iomap->inline_data
6. KASAN detects use-after-free write to freed memory
Fix by storing dibh in iomap->private and incrementing its refcount
with get_bh() in gfs2_iomap_begin(). The buffer is then properly
released in gfs2_iomap_end() after the inline write completes,
ensuring the page stays alive for the entire iomap operation.
Note: A C reproducer is not available for this issue. The fix is based
on analysis of the KASAN report and code review showing the buffer head
is freed before use.
[agruenba: Take buffer head reference in gfs2_iomap_begin() to avoid
leaks in gfs2_iomap_get() and gfs2_iomap_alloc().] |
| In the Linux kernel, the following vulnerability has been resolved:
drm/nouveau: fix u32 overflow in pushbuf reloc bounds check
nouveau_gem_pushbuf_reloc_apply() validates each relocation with
if (r->reloc_bo_offset + 4 > nvbo->bo.base.size)
but reloc_bo_offset is __u32 (uapi/drm/nouveau_drm.h) and the integer
literal 4 promotes to unsigned int, so the addition is performed in 32
bits and wraps before the comparison against the size_t bo size.
Cast to u64 so the addition happens in 64-bit arithmetic.
[ Add Fixes: tag. - Danilo ] |
| In the Linux kernel, the following vulnerability has been resolved:
mm/memfd_luo: fix physical address conversion in put_folios cleanup
In memfd_luo_retrieve_folios()'s put_folios cleanup path:
1. kho_restore_folio() expects a phys_addr_t (physical address) but
receives a raw PFN (pfolio->pfn). This causes kho_restore_page() to
check the wrong physical address (pfn << PAGE_SHIFT instead of the
actual physical address).
2. This loop lacks the !pfolio->pfn check that exists in the main
retrieval loop and memfd_luo_discard_folios(), which could
incorrectly process sparse file holes where pfn=0.
Fix by converting PFN to physical address with PFN_PHYS() and adding
the !pfolio->pfn check, matching the pattern used elsewhere in this file.
This issue was identified by the AI review.
https://sashiko.dev/#/patchset/20260323110747.193569-1-duanchenghao@kylinos.cn |
| In the Linux kernel, the following vulnerability has been resolved:
ALSA: usb-audio: stop parsing UAC2 rates at MAX_NR_RATES
parse_uac2_sample_rate_range() caps the number of enumerated
rates at MAX_NR_RATES, but it only breaks out of the current
rate loop. A malformed UAC2 RANGE response with additional
triplets continues parsing the remaining triplets and repeatedly
prints "invalid uac2 rates" while probe still holds
register_mutex.
Stop the whole parse once the cap is reached and return the
number of rates collected so far. |
| In the Linux kernel, the following vulnerability has been resolved:
net/smc: avoid early lgr access in smc_clc_wait_msg
A CLC decline can be received while the handshake is still in an early
stage, before the connection has been associated with a link group.
The decline handling in smc_clc_wait_msg() updates link-group level sync
state for first-contact declines, but that state only exists after link
group setup has completed. Guard the link-group update accordingly and
keep the per-socket peer diagnosis handling unchanged.
This preserves the existing sync_err handling for established link-group
contexts and avoids touching link-group state before it is available. |
| In the Linux kernel, the following vulnerability has been resolved:
crypto: authencesn - reject short ahash digests during instance creation
authencesn requires either a zero authsize or an authsize of at least
4 bytes because the ESN encrypt/decrypt paths always move 4 bytes of
high-order sequence number data at the end of the authenticated data.
While crypto_authenc_esn_setauthsize() already rejects explicit
non-zero authsizes in the range 1..3, crypto_authenc_esn_create()
still copied auth->digestsize into inst->alg.maxauthsize without
validating it. The AEAD core then initialized the tfm's default
authsize from that value.
As a result, selecting an ahash with digest size 1..3, such as
cbcmac(cipher_null), exposed authencesn instances whose default
authsize was invalid even though setauthsize() would have rejected the
same value. AF_ALG could then trigger the ESN tail handling with a
too-short tag and hit an out-of-bounds access.
Reject authencesn instances whose ahash digest size is in the invalid
non-zero range 1..3 so that no tfm can inherit an unsupported default
authsize. |
| In the Linux kernel, the following vulnerability has been resolved:
net: qrtr: ns: Free the node during ctrl_cmd_bye()
A node sends the BYE packet when it is about to go down. So the nameserver
should advertise the removal of the node to all remote and local observers
and free the node finally. But currently, the nameserver doesn't free the
node memory even after processing the BYE packet. This causes the node
memory to leak.
Hence, remove the node from Xarray list and free the node memory during
both success and failure case of ctrl_cmd_bye(). |
| In the Linux kernel, the following vulnerability has been resolved:
inotify: fix watch count leak when fsnotify_add_inode_mark_locked() fails
When fsnotify_add_inode_mark_locked() fails in inotify_new_watch(),
the error path calls inotify_remove_from_idr() but does not call
dec_inotify_watches() to undo the preceding inc_inotify_watches().
This leaks a watch count, and repeated failures can exhaust the
max_user_watches limit with -ENOSPC even when no watches are active.
Prior to commit 1cce1eea0aff ("inotify: Convert to using per-namespace
limits"), the watch count was incremented after fsnotify_add_mark_locked()
succeeded, so this path was not affected. The conversion moved
inc_inotify_watches() before the mark insertion without adding the
corresponding rollback.
Add the missing dec_inotify_watches() call in the error path. |
| In the Linux kernel, the following vulnerability has been resolved:
mm/damon/core: validate damos_quota_goal->nid for node_memcg_{used,free}_bp
Users can set damos_quota_goal->nid with arbitrary value for
node_memcg_{used,free}_bp. But DAMON core is using those for NODE-DATA()
without a validation of the value. This can result in out of bounds
memory access. The issue can actually triggered using DAMON user-space
tool (damo), like below.
$ sudo mkdir /sys/fs/cgroup/foo
$ sudo ./damo start --damos_action stat --damos_quota_interval 1s \
--damos_quota_goal node_memcg_used_bp 50% -1 /foo
$ sudo dmseg
[...]
[ 524.181426] Unable to handle kernel paging request at virtual address 0000000000002c00
Fix this issue by adding the validation of the given node id. If an
invalid node id is given, it returns 0% for used memory ratio, and 100%
for free memory ratio. |
| In the Linux kernel, the following vulnerability has been resolved:
erofs: fix the out-of-bounds nameoff handling for trailing dirents
Currently we already have boundary-checks for nameoffs, but the trailing
dirents are special since the namelens are calculated with strnlen()
with unchecked nameoffs.
If a crafted EROFS has a trailing dirent with nameoff >= maxsize,
maxsize - nameoff can underflow, causing strnlen() to read past the
directory block.
nameoff0 should also be verified to be a multiple of
`sizeof(struct erofs_dirent)` as well [1].
[1] https://sashiko.dev/#/patchset/20260416063511.3173774-1-hsiangkao%40linux.alibaba.com |
| In the Linux kernel, the following vulnerability has been resolved:
spi: fix resource leaks on device setup failure
Make sure to call controller cleanup() if spi_setup() fails while
registering a device to avoid leaking any resources allocated by
setup(). |
| In the Linux kernel, the following vulnerability has been resolved:
ALSA: control: Validate buf_len before strnlen() in snd_ctl_elem_init_enum_names()
snd_ctl_elem_init_enum_names() advances pointer p through the names
buffer while decrementing buf_len. If buf_len reaches zero but items
remain, the next iteration calls strnlen(p, 0).
While strnlen(p, 0) returns 0 and would hit the existing name_len == 0
error path, CONFIG_FORTIFY_SOURCE's fortified strnlen() first checks
maxlen against __builtin_dynamic_object_size(). When Clang loses track
of p's object size inside the loop, this triggers a BRK exception panic
before the return value is examined.
Add a buf_len == 0 guard at the loop entry to prevent calling fortified
strnlen() on an exhausted buffer.
Found by kernel fuzz testing through Xiaomi Smartphone. |
| In the Linux kernel, the following vulnerability has been resolved:
net: caif: clear client service pointer on teardown
`caif_connect()` can tear down an existing client after remote shutdown by
calling `caif_disconnect_client()` followed by `caif_free_client()`.
`caif_free_client()` releases the service layer referenced by
`adap_layer->dn`, but leaves that pointer stale.
When the socket is later destroyed, `caif_sock_destructor()` calls
`caif_free_client()` again and dereferences the freed service pointer.
Clear the client/service links before releasing the service object so
repeated teardown becomes harmless. |
| In the Linux kernel, the following vulnerability has been resolved:
fs: afs: revert mmap_prepare() change
Partially reverts commit 9d5403b1036c ("fs: convert most other
generic_file_*mmap() users to .mmap_prepare()").
This is because the .mmap invocation establishes a refcount, but
.mmap_prepare is called at a point where a merge or an allocation failure
might happen after the call, which would leak the refcount increment.
Functionality is being added to permit the use of .mmap_prepare in this
case, but in the interim, we need to fix this. |
| Jenkins Credentials Binding Plugin 720.v3f6decef43ea_ and earlier does not properly sanitize file names for file and zip file credentials, allowing attackers able to provide credentials to a job to write files to arbitrary locations on the node filesystem, which can lead to remote code execution if Jenkins is configured to allow a low-privileged user to configure file or zip file credentials used for a job running on the built-in node. |
| Missing Authorization vulnerability in Benbodhi SVG Support allows Exploiting Incorrectly Configured Access Control Security Levels.
This issue affects SVG Support: from n/a through 2.5.14. |
| When creating an export through the pretix API, API clients are
returned an UUID value for their export job (a long, random string like
35742818-c375-4d15-839f-d49aecce94d6). Using this UUID, the API client
can then request the actual file for download. The same kind of UUID is
used in other places in pretix when temporary files are generated for
internal use or download.
One remaining API endpoint, however, wrongfully did not verify if the
UUID used for download actually belongs to a file that is supposed to
be downloadable and belongs to the correct user. In reality, this is
hard to exploit because an attacker would need to have access to a valid
UUID for the file they desire which is unlikely to happen without a
separate security problem giving them access to logs etc. |
| Taipy 4.1.1, fixed in commit 129fd40, contains a path traversal vulnerability in the ElementLibrary.get_resource() method in taipy/gui/extension/library.py that allows unauthenticated attackers to escape the intended module directory by exploiting an incomplete path containment check using str.startswith() without a trailing path separator. Attackers can send crafted GET requests with path traversal segments targeting a prefix-matching sibling directory on disk, bypassing the directory containment check because Flask's path converter and Werkzeug's WSGI layer preserve the traversal segments while the resolved path still satisfies the flawed startswith comparison, enabling unauthorized file access outside the intended library directory. |
| Missing Authorization vulnerability in Prasad Kirpekar WP Meta and Date Remover allows Exploiting Incorrectly Configured Access Control Security Levels.
This issue affects WP Meta and Date Remover: from n/a through 2.3.6. |
| go-git is an extensible git implementation library written in pure Go. Prior to 5.19.0 and 6.0.0-alpha.3, go-git may parse malformed Git objects in a way that differs from upstream Git. When commit or tag objects contain ambiguous or malformed headers, go-git’s decoded representation may expose values differently from how Git itself would interpret or reject the same object. Additionally, go-git’s commit signing and verification logic operates over commit data reconstructed from go-git’s parsed representation rather than the original raw object bytes. As a result, go-git may sign or verify a commit payload that is not byte-for-byte equivalent to the object stored in the repository. This can cause a signature to appear valid for a commit whose displayed or effective metadata differs from the object that was intended to be signed. This vulnerability is fixed in 5.19.0 and 6.0.0-alpha.3. |
