| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| In the Linux kernel, the following vulnerability has been resolved:
net: usb: kalmia: validate USB endpoints
The kalmia driver should validate that the device it is probing has the
proper number and types of USB endpoints it is expecting before it binds
to it. If a malicious device were to not have the same urbs the driver
will crash later on when it blindly accesses these endpoints. |
| In the Linux kernel, the following vulnerability has been resolved:
Squashfs: check metadata block offset is within range
Syzkaller reports a "general protection fault in squashfs_copy_data"
This is ultimately caused by a corrupted index look-up table, which
produces a negative metadata block offset.
This is subsequently passed to squashfs_copy_data (via
squashfs_read_metadata) where the negative offset causes an out of bounds
access.
The fix is to check that the offset is within range in
squashfs_read_metadata. This will trap this and other cases. |
| In the Linux kernel, the following vulnerability has been resolved:
gve: fix incorrect buffer cleanup in gve_tx_clean_pending_packets for QPL
In DQ-QPL mode, gve_tx_clean_pending_packets() incorrectly uses the RDA
buffer cleanup path. It iterates num_bufs times and attempts to unmap
entries in the dma array.
This leads to two issues:
1. The dma array shares storage with tx_qpl_buf_ids (union).
Interpreting buffer IDs as DMA addresses results in attempting to
unmap incorrect memory locations.
2. num_bufs in QPL mode (counting 2K chunks) can significantly exceed
the size of the dma array, causing out-of-bounds access warnings
(trace below is how we noticed this issue).
UBSAN: array-index-out-of-bounds in
drivers/net/ethernet/drivers/net/ethernet/google/gve/gve_tx_dqo.c:178:5 index 18 is out of
range for type 'dma_addr_t[18]' (aka 'unsigned long long[18]')
Workqueue: gve gve_service_task [gve]
Call Trace:
<TASK>
dump_stack_lvl+0x33/0xa0
__ubsan_handle_out_of_bounds+0xdc/0x110
gve_tx_stop_ring_dqo+0x182/0x200 [gve]
gve_close+0x1be/0x450 [gve]
gve_reset+0x99/0x120 [gve]
gve_service_task+0x61/0x100 [gve]
process_scheduled_works+0x1e9/0x380
Fix this by properly checking for QPL mode and delegating to
gve_free_tx_qpl_bufs() to reclaim the buffers. |
| A vulnerability has been found in Nothings stb up to 2.30. This issue affects the function stbi__gif_load_next in the library stb_image.h of the component GIF Decoder. Such manipulation leads to denial of service. The attack may be launched remotely. The exploit has been disclosed to the public and may be used. The vendor was contacted early about this disclosure but did not respond in any way. |
| nimiq-blockchain provides persistent block storage for Nimiq's Rust implementation. In 1.3.0 and earlier, block timestamp validation enforces that timestamp >= parent.timestamp for non-skip blocks and timestamp == parent.timestamp + MIN_PRODUCER_TIMEOUT for skip blocks, but there is no visible upper bound check against the wall clock. A malicious block-producing validator can set block timestamps arbitrarily far in the future. This directly affects reward calculations via Policy::supply_at() and batch_delay() in blockchain/src/reward.rs, inflating the monetary supply beyond the intended emission schedule. |
| In the Linux kernel, the following vulnerability has been resolved:
apparmor: fix missing bounds check on DEFAULT table in verify_dfa()
The verify_dfa() function only checks DEFAULT_TABLE bounds when the state
is not differentially encoded.
When the verification loop traverses the differential encoding chain,
it reads k = DEFAULT_TABLE[j] and uses k as an array index without
validation. A malformed DFA with DEFAULT_TABLE[j] >= state_count,
therefore, causes both out-of-bounds reads and writes.
[ 57.179855] ==================================================================
[ 57.180549] BUG: KASAN: slab-out-of-bounds in verify_dfa+0x59a/0x660
[ 57.180904] Read of size 4 at addr ffff888100eadec4 by task su/993
[ 57.181554] CPU: 1 UID: 0 PID: 993 Comm: su Not tainted 6.19.0-rc7-next-20260127 #1 PREEMPT(lazy)
[ 57.181558] Hardware name: QEMU Standard PC (Q35 + ICH9, 2009), BIOS 1.16.3-debian-1.16.3-2 04/01/2014
[ 57.181563] Call Trace:
[ 57.181572] <TASK>
[ 57.181577] dump_stack_lvl+0x5e/0x80
[ 57.181596] print_report+0xc8/0x270
[ 57.181605] ? verify_dfa+0x59a/0x660
[ 57.181608] kasan_report+0x118/0x150
[ 57.181620] ? verify_dfa+0x59a/0x660
[ 57.181623] verify_dfa+0x59a/0x660
[ 57.181627] aa_dfa_unpack+0x1610/0x1740
[ 57.181629] ? __kmalloc_cache_noprof+0x1d0/0x470
[ 57.181640] unpack_pdb+0x86d/0x46b0
[ 57.181647] ? srso_alias_return_thunk+0x5/0xfbef5
[ 57.181653] ? srso_alias_return_thunk+0x5/0xfbef5
[ 57.181656] ? aa_unpack_nameX+0x1a8/0x300
[ 57.181659] aa_unpack+0x20b0/0x4c30
[ 57.181662] ? srso_alias_return_thunk+0x5/0xfbef5
[ 57.181664] ? stack_depot_save_flags+0x33/0x700
[ 57.181681] ? kasan_save_track+0x4f/0x80
[ 57.181683] ? kasan_save_track+0x3e/0x80
[ 57.181686] ? __kasan_kmalloc+0x93/0xb0
[ 57.181688] ? __kvmalloc_node_noprof+0x44a/0x780
[ 57.181693] ? aa_simple_write_to_buffer+0x54/0x130
[ 57.181697] ? policy_update+0x154/0x330
[ 57.181704] aa_replace_profiles+0x15a/0x1dd0
[ 57.181707] ? srso_alias_return_thunk+0x5/0xfbef5
[ 57.181710] ? __kvmalloc_node_noprof+0x44a/0x780
[ 57.181712] ? aa_loaddata_alloc+0x77/0x140
[ 57.181715] ? srso_alias_return_thunk+0x5/0xfbef5
[ 57.181717] ? _copy_from_user+0x2a/0x70
[ 57.181730] policy_update+0x17a/0x330
[ 57.181733] profile_replace+0x153/0x1a0
[ 57.181735] ? rw_verify_area+0x93/0x2d0
[ 57.181740] vfs_write+0x235/0xab0
[ 57.181745] ksys_write+0xb0/0x170
[ 57.181748] do_syscall_64+0x8e/0x660
[ 57.181762] entry_SYSCALL_64_after_hwframe+0x76/0x7e
[ 57.181765] RIP: 0033:0x7f6192792eb2
Remove the MATCH_FLAG_DIFF_ENCODE condition to validate all DEFAULT_TABLE
entries unconditionally. |
| Improper Validation of Specified Quantity in Input vulnerability in GalleryCreator SimpLy Gallery simply-gallery-block allows Accessing Functionality Not Properly Constrained by ACLs.This issue affects SimpLy Gallery: from n/a through <= 3.3.2. |
| In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: L2CAP: Fix accepting multiple L2CAP_ECRED_CONN_REQ
Currently the code attempts to accept requests regardless of the
command identifier which may cause multiple requests to be marked
as pending (FLAG_DEFER_SETUP) which can cause more than
L2CAP_ECRED_MAX_CID(5) to be allocated in l2cap_ecred_rsp_defer
causing an overflow.
The spec is quite clear that the same identifier shall not be used on
subsequent requests:
'Within each signaling channel a different Identifier shall be used
for each successive request or indication.'
https://www.bluetooth.com/wp-content/uploads/Files/Specification/HTML/Core-62/out/en/host/logical-link-control-and-adaptation-protocol-specification.html#UUID-32a25a06-4aa4-c6c7-77c5-dcfe3682355d
So this attempts to check if there are any channels pending with the
same identifier and rejects if any are found. |
| Improper Validation of Specified Quantity in Input vulnerability in Mitsubishi Electric Corporation CC-Link IE TSN Remote I/O module, CC-Link IE TSN Analog-Digital Converter module, CC-Link IE TSN Digital-Analog Converter module, CC-Link IE TSN FPGA module, CC-Link IE TSN Remote Station Communication LSI CP620 with GbE-PHY, MELSEC iQ-R Series CC-Link IE TSN Master/Local Module, MELSEC iQ-R Series Ethernet Interface Module, CC-Link IE TSN Master/Local Station Communication LSI CP610, MELSEC iQ-F Series FX5 CC-Link IE TSN Master/Local Module, MELSEC iQ-F Series FX5 Ethernet Module, and MELSEC iQ-F Series FX5-ENET/IP Ethernet Module allows a remote unauthenticated attacker to cause a Denial of Service condition in the products by sending specially crafted UDP packets. |
| In the Linux kernel, the following vulnerability has been resolved:
drm/amdgpu/userq: Do not allow userspace to trivially triger kernel warnings
Userspace can either deliberately pass in the too small num_fences, or the
required number can legitimately grow between the two calls to the userq
wait ioctl. In both cases we do not want the emit the kernel warning
backtrace since nothing is wrong with the kernel and userspace will simply
get an errno reported back. So lets simply drop the WARN_ONs.
(cherry picked from commit 2c333ea579de6cc20ea7bc50e9595ef72863e65c) |
| In the Linux kernel, the following vulnerability has been resolved:
ALSA: usb-audio: Use correct version for UAC3 header validation
The entry of the validators table for UAC3 AC header descriptor is
defined with the wrong protocol version UAC_VERSION_2, while it should
have been UAC_VERSION_3. This results in the validator never matching
for actual UAC3 devices (protocol == UAC_VERSION_3), causing their
header descriptors to bypass validation entirely. A malicious USB
device presenting a truncated UAC3 header could exploit this to cause
out-of-bounds reads when the driver later accesses unvalidated
descriptor fields.
The bug was introduced in the same commit as the recently fixed UAC3
feature unit sub-type typo, and appears to be from the same copy-paste
error when the UAC3 section was created from the UAC2 section. |
| An out-of-bounds read in the read_global_param() function (libavcodec/av1dec.c) of FFmpeg v8.0.1 allows attackers to cause a Denial of Service (DoS) via a crafted input. |
| Improper Validation of Specified Quantity in Input vulnerability in calliko Bonus for Woo bonus-for-woo allows Accessing Functionality Not Properly Constrained by ACLs.This issue affects Bonus for Woo: from n/a through <= 7.6.6. |
| Improper Validation of Specified Quantity in Input vulnerability in Cozmoslabs Profile Builder profile-builder allows Phishing.This issue affects Profile Builder: from n/a through <= 3.13.8. |
| Varnish 2.0.6 writes data to a log file without sanitizing non-printable characters, which might allow remote attackers to modify a window's title, or possibly execute arbitrary commands or overwrite files, via an HTTP request containing an escape sequence for a terminal emulator. NOTE: the vendor disputes the significance of this report, stating that "This is not a security problem in Varnish or any other piece of software which writes a logfile. The real problem is the mistaken belief that you can cat(1) a random logfile to your terminal safely. |
| Microsoft Windows XP SP2 and SP3, and Server 2003 SP1 and SP2, does not properly validate the option length field in Pragmatic General Multicast (PGM) packets, which allows remote attackers to cause a denial of service (infinite loop and system hang) via a crafted PGM packet, aka the "PGM Invalid Length Vulnerability." |
| src/sdp.c in bluez-libs 3.30 in BlueZ, and other bluez-libs before 3.34 and bluez-utils before 3.34 versions, does not validate string length fields in SDP packets, which allows remote SDP servers to cause a denial of service or possibly have unspecified other impact via a crafted length field that triggers excessive memory allocation or a buffer over-read. |
| Improper Validation of Specified Quantity in Input vulnerability in BoldGrid W3 Total Cache w3-total-cache allows Accessing Functionality Not Properly Constrained by ACLs.This issue affects W3 Total Cache: from n/a through <= 2.9.1. |
| Varnish Cache before 8.0.1 and Varnish Enterprise before 6.0.16r12, in certain unchecked req.url scenarios, mishandle URLs with a path of / for HTTP/1.1, potentially leading to cache poisoning or authentication bypass. |
| fast-jwt provides fast JSON Web Token (JWT) implementation. From 0.0.1 to before 6.2.0, setting up a custom cacheKeyBuilder method which does not properly create unique keys for different tokens can lead to cache collisions. This could cause tokens to be mis-identified during the verification process leading to valid tokens returning claims from different valid tokens and users being mis-identified as other users based on the wrong token. Version 6.2.0 contains a patch. |
