| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| A vulnerability in the Simple Network Management Protocol version 3 (SNMPv3) access control functionality of Cisco Adaptive Security Appliance (ASA) Software and Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to query SNMP data. This vulnerability is due to ineffective access control. An attacker could exploit this vulnerability by sending an SNMPv3 query to an affected device from a host that is not permitted by the SNMPv3 access control list. A successful exploit could allow the attacker to send an SNMP query to an affected device and retrieve information from the device. The attacker would need valid credentials to perform the SNMP query. |
| A vulnerability in the Transport Layer Security version 1.3 (TLS 1.3) policy with URL category functionality for Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to bypass a configured TLS 1.3 policy to block traffic for a specific URL. The vulnerability is due to a logic error with Snort handling of the connection with the TLS 1.3 policy and URL category configuration. An attacker could exploit this vulnerability by sending crafted TLS 1.3 connections to an affected device. A successful exploit could allow the attacker to bypass the TLS 1.3 policy and access URLs that are outside the affected device and normally would be dropped. |
| A vulnerability in the management access list configuration of Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to bypass a configured management interface access list on an affected system. The vulnerability is due to the configuration of different management access lists, with ports allowed in one access list and denied in another. An attacker could exploit this vulnerability by sending crafted remote management traffic to the local IP address of an affected system. A successful exploit could allow the attacker to bypass the configured management access list policies, and traffic to the management interface would not be properly denied. |
| Multiple Cisco products are affected by a vulnerability in the Snort detection engine that could allow an unauthenticated, remote attacker to bypass a configured File Policy for HTTP. The vulnerability is due to incorrect detection of modified HTTP packets used in chunked responses. An attacker could exploit this vulnerability by sending crafted HTTP packets through an affected device. A successful exploit could allow the attacker to bypass a configured File Policy for HTTP packets and deliver a malicious payload. |
| Multiple vulnerabilities in the Server Message Block Version 2 (SMB2) processor of the Snort detection engine on multiple Cisco products could allow an unauthenticated, remote attacker to bypass the configured policies or cause a denial of service (DoS) condition on an affected device.
These vulnerabilities are due to improper management of system resources when the Snort detection engine is processing SMB2 traffic. An attacker could exploit these vulnerabilities by sending a high rate of certain types of SMB2 packets through an affected device. A successful exploit could allow the attacker to trigger a reload of the Snort process, resulting in a DoS condition.
Note: When the snort preserve-connection option is enabled for the Snort detection engine, a successful exploit could also allow the attacker to bypass the configured policies and deliver a malicious payload to the protected network. The snort preserve-connection setting is enabled by default. See the Details ["#details"] section of this advisory for more information.
Note: Only products that have Snort 3 configured are affected. Products that are configured with Snort 2 are not affected. |
| Multiple vulnerabilities in the Server Message Block Version 2 (SMB2) processor of the Snort detection engine on multiple Cisco products could allow an unauthenticated, remote attacker to bypass the configured policies or cause a denial of service (DoS) condition on an affected device.
These vulnerabilities are due to improper management of system resources when the Snort detection engine is processing SMB2 traffic. An attacker could exploit these vulnerabilities by sending a high rate of certain types of SMB2 packets through an affected device. A successful exploit could allow the attacker to trigger a reload of the Snort process, resulting in a DoS condition.
Note: When the snort preserve-connection option is enabled for the Snort detection engine, a successful exploit could also allow the attacker to bypass the configured policies and deliver a malicious payload to the protected network. The snort preserve-connection setting is enabled by default. See the Details ["#details"] section of this advisory for more information.
Note: Only products that have Snort 3 configured are affected. Products that are configured with Snort 2 are not affected. |
| Multiple vulnerabilities in the payload inspection for Ethernet Industrial Protocol (ENIP) traffic for Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to bypass configured rules for ENIP traffic. These vulnerabilities are due to incomplete processing during deep packet inspection for ENIP packets. An attacker could exploit these vulnerabilities by sending a crafted ENIP packet to the targeted interface. A successful exploit could allow the attacker to bypass configured access control and intrusion policies that should be activated for the ENIP packet. |
| A vulnerability in the password change feature of Cisco Firepower Management Center (FMC) software could allow an unauthenticated, remote attacker to determine valid user names on an affected device.
This vulnerability is due to improper authentication of password update responses. An attacker could exploit this vulnerability by forcing a password reset on an affected device. A successful exploit could allow the attacker to determine valid user names in the unauthenticated response to a forced password reset. |
| A vulnerability in the management web server of Cisco Firepower Threat Defense (FTD) Software could allow an authenticated, remote attacker with high privileges to execute configuration commands on an affected system.
This vulnerability exists because access to HTTPS endpoints is not properly restricted on an affected device. An attacker could exploit this vulnerability by sending specific messages to the affected HTTPS handler. A successful exploit could allow the attacker to perform configuration changes on the affected system, which should be configured and managed only through Cisco Firepower Management Center (FMC) Software. |
| A vulnerability in the detection engine of Cisco Adaptive Security Appliance (ASA) Software and Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, adjacent attacker to send data directly to the kernel of an affected device. The vulnerability exists because the software improperly filters Ethernet frames sent to an affected device. An attacker could exploit this vulnerability by sending crafted packets to the management interface of an affected device. A successful exploit could allow the attacker to bypass the Layer 2 (L2) filters and send data directly to the kernel of the affected device. A malicious frame successfully delivered would make the target device generate a specific syslog entry. |
| In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: L2CAP: cancel pending_rx_work before taking conn->lock
l2cap_conn_del() takes conn->lock and then calls cancel_work_sync() for
pending_rx_work. process_pending_rx() takes the same mutex, so teardown
can deadlock against the worker it is flushing.
This issue was found by our static analysis tool and then manually
reviewed against the current tree.
The grounded PoC kept the l2cap_conn_ready() -> queue_work(...,
&conn->pending_rx_work) submit path, the l2cap_conn_del() ->
cancel_work_sync(&conn->pending_rx_work) teardown path, and the
process_pending_rx() -> mutex_lock(&conn->lock) worker edge. Lockdep
WARNING: possible circular locking dependency detected
process_pending_rx+0x21/0x2a [vuln_msv]
l2cap_conn_del.constprop.0+0x3f/0x4e [vuln_msv]
*** DEADLOCK ***
Cancel pending_rx_work before taking conn->lock, matching the existing
lock-before-drain ordering used for the two delayed works in the same
teardown path. The pending_rx queue is still purged after the work has
been cancelled and conn->lock has been acquired. |
| In the Linux kernel, the following vulnerability has been resolved:
batman-adv: tp_meter: fix tp_vars reference leak in receiver shutdown
The receiver shutdown timer handler, batadv_tp_receiver_shutdown(), is
responsible for releasing the tp_vars reference it holds. However, the
existing logic for coordinating this release with batadv_tp_stop_all() was
flawed.
timer_shutdown_sync() guarantees the timer will not fire again after it
returns, but it returns non-zero only when the timer was pending at the
time of the call. If the timer had already expired (and
batadv_tp_stop_all() would unsucessfully try to rearm itself),
batadv_tp_stop_all() skips its batadv_tp_vars_put(), and
batadv_tp_receiver_shutdown() fails to put its own reference as well.
Fix this by introducing a new atomic variable receiving that is set to 1
when the receiver is initialized and cleared atomically with atomic_xchg()
by whichever side claims it first. Only the side that observes the
transition from 1 to 0 is responsible for releasing the tp_vars timer
reference, eliminating the uncertainty. |
| A vulnerability was found in the fs/inode.c:inode_init_owner() function logic of the LInux kernel that allows local users to create files for the XFS file-system with an unintended group ownership and with group execution and SGID permission bits set, in a scenario where a directory is SGID and belongs to a certain group and is writable by a user who is not a member of this group. This can lead to excessive permissions granted in case when they should not. This vulnerability is similar to the previous CVE-2018-13405 and adds the missed fix for the XFS. |
| An elevation of privilege vulnerability exists because of overly permissive Access Control Lists (ACLs) on multiple system files, including the Security Accounts Manager (SAM) database. An attacker who successfully exploited this vulnerability could run arbitrary code with SYSTEM privileges. An attacker could then install programs; view, change, or delete data; or create new accounts with full user rights.
An attacker must have the ability to execute code on a victim system to exploit this vulnerability.
After installing this security update, you must manually delete all shadow copies of system files, including the SAM database, to fully mitigate this vulnerabilty. Simply installing this security update will not fully mitigate this vulnerability. See KB5005357- Delete Volume Shadow Copies. |
| Windows Recovery Environment Agent Elevation of Privilege Vulnerability |
| Windows LSA Spoofing Vulnerability |
| Improper access control in Extensible Storage Engine (ESENT) allows an authorized attacker to elevate privileges locally. |
| Improper authorization in Windows Installer allows an authorized attacker to elevate privileges locally. |
| In the Linux kernel, the following vulnerability has been resolved:
drm/v3d: Stop active perfmon if it is being destroyed
If the active performance monitor (`v3d->active_perfmon`) is being
destroyed, stop it first. Currently, the active perfmon is not
stopped during destruction, leaving the `v3d->active_perfmon` pointer
stale. This can lead to undefined behavior and instability.
This patch ensures that the active perfmon is stopped before being
destroyed, aligning with the behavior introduced in commit
7d1fd3638ee3 ("drm/v3d: Stop the active perfmon before being destroyed"). |
| In the Linux kernel, the following vulnerability has been resolved:
mm: hugetlb: independent PMD page table shared count
The folio refcount may be increased unexpectly through try_get_folio() by
caller such as split_huge_pages. In huge_pmd_unshare(), we use refcount
to check whether a pmd page table is shared. The check is incorrect if
the refcount is increased by the above caller, and this can cause the page
table leaked:
BUG: Bad page state in process sh pfn:109324
page: refcount:0 mapcount:0 mapping:0000000000000000 index:0x66 pfn:0x109324
flags: 0x17ffff800000000(node=0|zone=2|lastcpupid=0xfffff)
page_type: f2(table)
raw: 017ffff800000000 0000000000000000 0000000000000000 0000000000000000
raw: 0000000000000066 0000000000000000 00000000f2000000 0000000000000000
page dumped because: nonzero mapcount
...
CPU: 31 UID: 0 PID: 7515 Comm: sh Kdump: loaded Tainted: G B 6.13.0-rc2master+ #7
Tainted: [B]=BAD_PAGE
Hardware name: QEMU KVM Virtual Machine, BIOS 0.0.0 02/06/2015
Call trace:
show_stack+0x20/0x38 (C)
dump_stack_lvl+0x80/0xf8
dump_stack+0x18/0x28
bad_page+0x8c/0x130
free_page_is_bad_report+0xa4/0xb0
free_unref_page+0x3cc/0x620
__folio_put+0xf4/0x158
split_huge_pages_all+0x1e0/0x3e8
split_huge_pages_write+0x25c/0x2d8
full_proxy_write+0x64/0xd8
vfs_write+0xcc/0x280
ksys_write+0x70/0x110
__arm64_sys_write+0x24/0x38
invoke_syscall+0x50/0x120
el0_svc_common.constprop.0+0xc8/0xf0
do_el0_svc+0x24/0x38
el0_svc+0x34/0x128
el0t_64_sync_handler+0xc8/0xd0
el0t_64_sync+0x190/0x198
The issue may be triggered by damon, offline_page, page_idle, etc, which
will increase the refcount of page table.
1. The page table itself will be discarded after reporting the
"nonzero mapcount".
2. The HugeTLB page mapped by the page table miss freeing since we
treat the page table as shared and a shared page table will not be
unmapped.
Fix it by introducing independent PMD page table shared count. As
described by comment, pt_index/pt_mm/pt_frag_refcount are used for s390
gmap, x86 pgds and powerpc, pt_share_count is used for x86/arm64/riscv
pmds, so we can reuse the field as pt_share_count. |
