| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| In the Linux kernel, the following vulnerability has been resolved:
pmdomain: imx93-blk-ctrl: Extract PHY as shared domain for DSI/CSI
The MIPI DSI and CSI domains share control bits for clock and reset, which
can lead to incorrect behavior if one domain disables the shared resource
while the other is still active.
To fix the issue, introduce a shared MIPI PHY power domain to own the
common resources and make DSI and CSI its subdomains. This ensures the
shared bits are properly managed and not disabled while still in use. |
| In the Linux kernel, the following vulnerability has been resolved:
wifi: rt2x00: avoid full teardown before work setup in probe
rt2x00lib_probe_dev() uses the full rt2x00lib_remove_dev() teardown for
all probe failures. However, drv_data allocation and workqueue allocation
can fail before intf_work, autowakeup_work and sleep_work have been
initialized.
Do not enter the full remove path until the probe has reached the point
where those work items are set up. Return directly for drv_data allocation
failure, and use a small early cleanup path for workqueue allocation
failure.
This issue was found by our static analysis tool and then confirmed by
manual review of rt2x00lib_probe_dev() and rt2x00lib_remove_dev(). The
early probe exits should not call a common teardown path that assumes the
later work setup has already completed.
A QEMU PoC forced alloc_ordered_workqueue() to fail before the work
initializers are reached. The resulting fail path entered
rt2x00lib_remove_dev(), and DEBUG_OBJECTS reported invalid work drains with
rt2x00lib_probe_dev() and rt2x00lib_remove_dev() in the stack. |
| In the Linux kernel, the following vulnerability has been resolved:
wifi: brcmfmac: cyw: fix heap overflow on a short auth frame
brcmf_notify_auth_frame_rx() takes the frame length from the firmware
event and copies the frame body with the management header offset
subtracted:
u32 mgmt_frame_len = e->datalen - sizeof(struct brcmf_rx_mgmt_data);
...
memcpy(&mgmt_frame->u, frame,
mgmt_frame_len - offsetof(struct ieee80211_mgmt, u));
The only length check is e->datalen >= sizeof(*rxframe), so mgmt_frame_len
can be anything from 0 up. offsetof(struct ieee80211_mgmt, u) is 24. When
mgmt_frame_len is below that, the subtraction wraps as an unsigned value to
a huge length. The memcpy then runs far past the kzalloc'd buffer. A
malicious or malfunctioning AP can make the frame short during the
external SAE auth exchange, so this is a remotely triggered heap overflow.
Reject frames shorter than the management header offset before the copy. |
| Missing authentication for critical function in Windows Credential Guard allows an authorized attacker to perform spoofing locally. |
| Incorrect authorization in Windows Hello allows an authorized attacker to bypass a security feature locally. |
| Use after free in Windows Console Driver allows an authorized attacker to elevate privileges locally. |
| Use after free in Windows Push Notifications allows an authorized attacker to elevate privileges locally. |
| In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: btrtl: validate firmware patch bounds
rtlbt_parse_firmware() copies patch_length - 4 bytes before appending the
firmware version. A malformed firmware patch shorter than the version field
can make this subtraction underflow and turn the copy into an oversized
read and write during Bluetooth setup.
The existing patch_offset + patch_length check can also wrap on 32-bit
architectures. Validate the patch length and range without arithmetic
overflow before allocating or copying the patch. |
| In the Linux kernel, the following vulnerability has been resolved:
ipvs: fix more places with wrong ipv6 transport offsets
Sashiko reports for more incorrect IPv6 transport offsets.
The app code for TCP was assuming IPv4 network header
even after the ipvsh argument was provided. This can
cause problems with apps over IPv6. As for the only
official app in the kernel tree (FTP) this problem is
harmless because we use Netfilter to mangle the FTP
ports and we do not adjust the TCP seq numbers.
Also, provide correct offset of the ICMPV6 header in
ip_vs_out_icmp_v6() for correct checksum checks when
the IPv6 packet has extension headers. |
| In the Linux kernel, the following vulnerability has been resolved:
wifi: cfg80211: validate EHT MLE before MLD ID read
cfg80211_gen_new_ie() copies ML probe response elements from
the parent frame when the parent EHT multi-link element has an
MLD ID matching the nontransmitted BSSID index.
The code only checked that the extension element had more than
one byte before calling ieee80211_mle_get_mld_id(). That helper
assumes a BASIC MLE with enough common info and documents that
callers must first use ieee80211_mle_type_ok().
Attack chain:
malicious AP sends a short EHT MLE in an MBSSID beacon.
cfg80211_inform_bss_frame_data() stores the copied IE buffer.
cfg80211_parse_mbssid_data() builds the nontransmitted BSS IE.
cfg80211_gen_new_ie() sees the EHT MLE in the parent frame.
ieee80211_mle_get_mld_id() then reads past the IE boundary.
Validate the MLE type and size before reading the MLD ID. This
matches the contract required by the MLE helper and rejects the
short element before any internal MLE fields are accessed. |
| In the Linux kernel, the following vulnerability has been resolved:
wifi: mac80211: validate extension-frame layout before RX
Extension frames only have the extension header at the regular 802.11
header offset. The generic RX path can still reach helpers and interface
dispatch code that read regular header address fields before unsupported
extension subtypes are dropped.
mac80211 currently only handles S1G beacon extension frames. Drop other
extension subtypes before they can reach regular-header RX processing.
For S1G beacons, linearize the SKB with the management-frame path and
require the fixed S1G beacon header, including optional fixed fields
indicated by frame control, before generic RX dispatch.
Route S1G beacons through the station/default-link RX path without
regular-header station lookup. Avoid regular-header address reads in the
mac80211 RX paths that process S1G extension beacons, including
accept-frame, duplicate-detection, address-copy, and MLO
address-translation paths.
Also make ieee80211_get_bssid() length-safe before returning the S1G
source-address pointer. |
| In the Linux kernel, the following vulnerability has been resolved:
device property: initialize the remaining fields of fwnode_handle in fwnode_init()
If a firmware node is allocated on the stack (for instance: temporary
software node whose life-time we control) or on the heap - but using a
non-zeroing allocation function - and initialized using fwnode_init(),
its secondary pointer will contain uninitialized memory which likely
will be neither NULL nor IS_ERR() and so may end up being dereferenced
(for example: in dev_to_swnode()). Set fwnode->secondary to NULL on
initialization. While at it: initialize the remaining fields of struct
fwnode_handle too just to be sure.
[ Fix typo in commit message. - Danilo ] |
| In the Linux kernel, the following vulnerability has been resolved:
KVM: s390: pci: Fix handling of AIF enable without AISB
When a guest seeks to register IRQs without a summary bit specified,
ensure that the associated GAITE then stores 0 for the guest AISB
location instead of virt_to_phys(page_address(NULL)). |
| In the Linux kernel, the following vulnerability has been resolved:
s390/zcrypt: Fix buffer over-read in cca_cipher2protkey
Add validation of both the actual key buffer size and token length
fields in all the cca_check_sec*token() functions. Additionally check
in cca_gencipherkey() for possible underflow with returned key size.
The CCA token structures contain user-controlled len fields that
were used in operations without proper validation against both the
actual buffer size and minimum token structure size. An attacker
could set this field larger than the actual buffer size, leading to
reading beyond buffer boundaries. This may result in a kernel crash or
exposure of memory via sending this as part of a request down to the
crypto card. Also an attacker could have used a very small len value
and thus enforce a buffer under-run which may produce similar effects
as a over-read.
So now a key must
- key buf length must be at least sizeof the token struct
- the key len field inside the token must fit into the range of
sizeof key token struct ... key buf length |
| In modem, there is a possible information disclosure due to missing filtering of sensitive data in crash dumps. This could lead to local information disclosure with no additional execution privileges needed. |
| In the Linux kernel, the following vulnerability has been resolved:
staging: rtl8723bs: fix OOB reads in is_ap_in_tkip() IE loop
The loop in is_ap_in_tkip() iterates over IEs without verifying that
enough bytes remain before dereferencing the IE header or its payload:
- pIE->element_id and pIE->length are read without checking that
i + sizeof(*pIE) <= ie_length, so a truncated IE at the end of the
buffer causes an OOB read.
- For WLAN_EID_VENDOR_SPECIFIC the code compares pIE->data + 12,
which requires pIE->length >= 16. For WLAN_EID_RSN it compares
pIE->data + 8, requiring pIE->length >= 12. Neither requirement
is checked.
Add the missing IE header and payload bounds checks and guard each
data access with an explicit pIE->length minimum, matching the
pattern established in update_beacon_info(). |
| In the Linux kernel, the following vulnerability has been resolved:
nvmet-tcp: Fix potential UAF when ddgst mismatch
Shivam Kumar found via vulnerability testing:
When data digest is enabled on an NVMe/TCP connection and a digest
mismatch occurs on a non-final H2C_DATA PDU during an R2T-based
data transfer, the digest error handler in nvmet_tcp_try_recv_ddgst()
calls nvmet_req_uninit() — which performs percpu_ref_put() on the
submission queue — but does NOT mark the command as completed. It
does not set cqe->status, does not modify rbytes_done, and does not
clear any flag. When the subsequent fatal error triggers queue
teardown, nvmet_tcp_uninit_data_in_cmds() iterates all commands,
checks nvmet_tcp_need_data_in() for each one, and finds that the
already-uninited command still appears to need data (because
rbytes_done < transfer_len and cqe->status == 0). It therefore calls
nvmet_req_uninit() a second time on the same command — a double
percpu_ref_put against a single percpu_ref_get. |
| In the Linux kernel, the following vulnerability has been resolved:
nvmet-tcp: check INIT_FAILED before nvmet_req_uninit in digest error path
In nvmet_tcp_try_recv_ddgst(), when a data digest mismatch is detected,
nvmet_req_uninit() is called unconditionally. However, if the command
arrived via the nvmet_tcp_handle_req_failure() path, nvmet_req_init()
had returned false and percpu_ref_tryget_live() was never executed. The
unconditional percpu_ref_put() inside nvmet_req_uninit() then causes a
refcount underflow, leading to a WARNING in
percpu_ref_switch_to_atomic_rcu, a use-after-free diagnostic, and
eventually a permanent workqueue deadlock.
Check cmd->flags & NVMET_TCP_F_INIT_FAILED before calling
nvmet_req_uninit(), matching the existing pattern in
nvmet_tcp_execute_request(). |
| In the Linux kernel, the following vulnerability has been resolved:
fs/ntfs3: validate lcns_follow in log_replay conversion
log_replay() converts DIR_PAGE_ENTRY_32 records into DIR_PAGE_ENTRY
records when replaying version 0 restart tables.
During this conversion, the memmove() length is derived directly from
the on-disk lcns_follow field:
memmove(&dp->vcn, &dp0->vcn_low,
2 * sizeof(u64) +
le32_to_cpu(dp->lcns_follow) * sizeof(u64));
check_rstbl() validates restart table structure, but does not constrain
per-entry lcns_follow values relative to the entry size. A malformed
filesystem image can provide an oversized lcns_follow value, causing
the conversion memmove() to access memory beyond the bounds of the
allocated restart table buffer.
The same field is later used to bound iteration over page_lcns[],
so validating lcns_follow during conversion also prevents downstream
out-of-bounds access from the same malformed metadata.
Compute the maximum valid lcns_follow from the already-validated
restart table entry size and reject entries that exceed this bound.
Reuse the existing t16/t32 scratch variables already declared in
log_replay() to avoid introducing new declarations.
[almaz.alexandrovich@paragon-software.com: fixed the conflicts] |
| In the Linux kernel, the following vulnerability has been resolved:
fs/ntfs3: bound NTFS_DE view.data_off in UpdateRecordData{Root,Allocation}
In do_action()'s UpdateRecordDataRoot (fslog.c:3489) and
UpdateRecordDataAllocation (fslog.c:3697) cases, the memmove
destination is `Add2Ptr(e, le16_to_cpu(e->view.data_off))`,
where e->view.data_off comes from an on-disk NTFS_DE inside
an INDEX_ROOT or INDEX_BUFFER. Neither case validates
view.data_off + dlen against e->size; the existing
check_if_index_root / check_if_alloc_index helpers walk the
entry chain and validate the entry's offset, but not its
internal view fields.
The neighbouring read sites (e.g., fs/ntfs3/index.c when
iterating view entries) check view.data_off + view.data_size
<= e->size. Apply the same bound at the two memmove sites.
Reproduced under UML+KASAN on mainline 8d90b09e6741 via
pr_warn-only probe instrumentation: with view.data_off forced
to 0xFFFC, the memmove writes 32 bytes past the end of the
NTFS_DE.
This is similar in shape to Pavitra Jha's 2026-05-02 patch
"fs/ntfs3: prevent oob in case UpdateRecordDataRoot"
(<20260502105008.21827-1-jhapavitra98@gmail.com>) which
proposes calling ntfs3_bad_de_range(); that helper does not
exist in mainline. This patch uses inline checks. |
