| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| Authenticated user can bypass authorization in Ribblr - Crochet & Knitting iOS application |
| In the Linux kernel, the following vulnerability has been resolved:
netfilter: ip6t_eui64: reject invalid MAC header for all packets
`eui64_mt6()` derives a modified EUI-64 from the Ethernet source address
and compares it with the low 64 bits of the IPv6 source address.
The existing guard only rejects an invalid MAC header when
`par->fragoff != 0`. For packets with `par->fragoff == 0`, `eui64_mt6()`
can still reach `eth_hdr(skb)` even when the MAC header is not valid.
Fix this by removing the `par->fragoff != 0` condition so that packets
with an invalid MAC header are rejected before accessing `eth_hdr(skb)`. |
| In the Linux kernel, the following vulnerability has been resolved:
net: sched: act_csum: validate nested VLAN headers
tcf_csum_act() walks nested VLAN headers directly from skb->data when an
skb still carries in-payload VLAN tags. The current code reads
vlan->h_vlan_encapsulated_proto and then pulls VLAN_HLEN bytes without
first ensuring that the full VLAN header is present in the linear area.
If only part of an inner VLAN header is linearized, accessing
h_vlan_encapsulated_proto reads past the linear area, and the following
skb_pull(VLAN_HLEN) may violate skb invariants.
Fix this by requiring pskb_may_pull(skb, VLAN_HLEN) before accessing and
pulling each nested VLAN header. If the header still is not fully
available, drop the packet through the existing error path. |
| In the Linux kernel, the following vulnerability has been resolved:
netfilter: xt_multiport: validate range encoding in checkentry
ports_match_v1() treats any non-zero pflags entry as the start of a
port range and unconditionally consumes the next ports[] element as
the range end.
The checkentry path currently validates protocol, flags and count, but
it does not validate the range encoding itself. As a result, malformed
rules can mark the last slot as a range start or place two range starts
back to back, leaving ports_match_v1() to step past the last valid
ports[] element while interpreting the rule.
Reject malformed multiport v1 rules in checkentry by validating that
each range start has a following element and that the following element
is not itself marked as another range start. |
| In the Linux kernel, the following vulnerability has been resolved:
rxrpc: only handle RESPONSE during service challenge
Only process RESPONSE packets while the service connection is still in
RXRPC_CONN_SERVICE_CHALLENGING. Check that state under state_lock before
running response verification and security initialization, then use a local
secured flag to decide whether to queue the secured-connection work after
the state transition. This keeps duplicate or late RESPONSE packets from
re-running the setup path and removes the unlocked post-transition state
test. |
| In the Linux kernel, the following vulnerability has been resolved:
af_unix: read UNIX_DIAG_VFS data under unix_state_lock
Exact UNIX diag lookups hold a reference to the socket, but not to
u->path. Meanwhile, unix_release_sock() clears u->path under
unix_state_lock() and drops the path reference after unlocking.
Read the inode and device numbers for UNIX_DIAG_VFS while holding
unix_state_lock(), then emit the netlink attribute after dropping the
lock.
This keeps the VFS data stable while the reply is being built. |
| In the Linux kernel, the following vulnerability has been resolved:
nfc: llcp: add missing return after LLCP_CLOSED checks
In nfc_llcp_recv_hdlc() and nfc_llcp_recv_disc(), when the socket
state is LLCP_CLOSED, the code correctly calls release_sock() and
nfc_llcp_sock_put() but fails to return. Execution falls through to
the remainder of the function, which calls release_sock() and
nfc_llcp_sock_put() again. This results in a double release_sock()
and a refcount underflow via double nfc_llcp_sock_put(), leading to
a use-after-free.
Add the missing return statements after the LLCP_CLOSED branches
in both functions to prevent the fall-through. |
| In the Linux kernel, the following vulnerability has been resolved:
i2c: s3c24xx: check the size of the SMBUS message before using it
The first byte of an i2c SMBUS message is the size, and it should be
verified to ensure that it is in the range of 0..I2C_SMBUS_BLOCK_MAX
before processing it.
This is the same logic that was added in commit a6e04f05ce0b ("i2c:
tegra: check msg length in SMBUS block read") to the i2c tegra driver. |
| In the Linux kernel, the following vulnerability has been resolved:
staging: rtl8723bs: initialize le_tmp64 in rtw_BIP_verify()
Initialize le_tmp64 to zero in rtw_BIP_verify() to prevent using
uninitialized data.
Smatch warns that only 6 bytes are copied to this 8-byte (u64)
variable, leaving the last two bytes uninitialized:
drivers/staging/rtl8723bs/core/rtw_security.c:1308 rtw_BIP_verify()
warn: not copying enough bytes for '&le_tmp64' (8 vs 6 bytes)
Initializing the variable at the start of the function fixes this
warning and ensures predictable behavior. |
| In the Linux kernel, the following vulnerability has been resolved:
HID: alps: fix NULL pointer dereference in alps_raw_event()
Commit ecfa6f34492c ("HID: Add HID_CLAIMED_INPUT guards in raw_event
callbacks missing them") attempted to fix up the HID drivers that had
missed the previous fix that was done in 2ff5baa9b527 ("HID: appleir:
Fix potential NULL dereference at raw event handle"), but the alps
driver was missed.
Fix this up by properly checking in the hid-alps driver that it had been
claimed correctly before attempting to process the raw event. |
| In the Linux kernel, the following vulnerability has been resolved:
HID: core: clamp report_size in s32ton() to avoid undefined shift
s32ton() shifts by n-1 where n is the field's report_size, a value that
comes directly from a HID device. The HID parser bounds report_size
only to <= 256, so a broken HID device can supply a report descriptor
with a wide field that triggers shift exponents up to 256 on a 32-bit
type when an output report is built via hid_output_field() or
hid_set_field().
Commit ec61b41918587 ("HID: core: fix shift-out-of-bounds in
hid_report_raw_event") added the same n > 32 clamp to the function
snto32(), but s32ton() was never given the same fix as I guess syzbot
hadn't figured out how to fuzz a device the same way.
Fix this up by just clamping the max value of n, just like snto32()
does. |
| In the Linux kernel, the following vulnerability has been resolved:
net: usb: cdc-phonet: fix skb frags[] overflow in rx_complete()
A malicious USB device claiming to be a CDC Phonet modem can overflow
the skb_shared_info->frags[] array by sending an unbounded sequence of
full-page bulk transfers.
Drop the skb and increment the length error when the frag limit is
reached. This matches the same fix that commit f0813bcd2d9d ("net:
wwan: t7xx: fix potential skb->frags overflow in RX path") did for the
t7xx driver. |
| In the Linux kernel, the following vulnerability has been resolved:
NFC: digital: Bounds check NFC-A cascade depth in SDD response handler
The NFC-A anti-collision cascade in digital_in_recv_sdd_res() appends 3
or 4 bytes to target->nfcid1 on each round, but the number of cascade
rounds is controlled entirely by the peer device. The peer sets the
cascade tag in the SDD_RES (deciding 3 vs 4 bytes) and the
cascade-incomplete bit in the SEL_RES (deciding whether another round
follows).
ISO 14443-3 limits NFC-A to three cascade levels and target->nfcid1 is
sized accordingly (NFC_NFCID1_MAXSIZE = 10), but nothing in the driver
actually enforces this. This means a malicious peer can keep the
cascade running, writing past the heap-allocated nfc_target with each
round.
Fix this by rejecting the response when the accumulated UID would exceed
the buffer.
Commit e329e71013c9 ("NFC: nci: Bounds check struct nfc_target arrays")
fixed similar missing checks against the same field on the NCI path. |
| In the Linux kernel, the following vulnerability has been resolved:
ALSA: fireworks: bound device-supplied status before string array lookup
The status field in an EFW response is a 32-bit value supplied by the
firewire device. efr_status_names[] has 17 entries so a status value
outside that range goes off into the weeds when looking at the %s value.
Even worse, the status could return EFR_STATUS_INCOMPLETE which is
0x80000000, and is obviously not in that array of potential strings.
Fix this up by properly bounding the index against the array size and
printing "unknown" if it's not recognized. |
| In the Linux kernel, the following vulnerability has been resolved:
fbdev: tdfxfb: avoid divide-by-zero on FBIOPUT_VSCREENINFO
Much like commit 19f953e74356 ("fbdev: fb_pm2fb: Avoid potential divide
by zero error"), we also need to prevent that same crash from happening
in the udlfb driver as it uses pixclock directly when dividing, which
will crash. |
| In the Linux kernel, the following vulnerability has been resolved:
usb: gadget: f_ncm: validate minimum block_len in ncm_unwrap_ntb()
The block_len read from the host-supplied NTB header is checked against
ntb_max but has no lower bound. When block_len is smaller than
opts->ndp_size, the bounds check of:
ndp_index > (block_len - opts->ndp_size)
will underflow producing a huge unsigned value that ndp_index can never
exceed, defeating the check entirely.
The same underflow occurs in the datagram index checks against block_len
- opts->dpe_size. With those checks neutered, a malicious USB host can
choose ndp_index and datagram offsets that point past the actual
transfer, and the skb_put_data() copies adjacent kernel memory into the
network skb.
Fix this by rejecting block lengths that cannot hold at least the NTB
header plus one NDP. This will make block_len - opts->ndp_size and
block_len - opts->dpe_size both well-defined.
Commit 8d2b1a1ec9f5 ("CDC-NCM: avoid overflow in sanity checking") fixed
a related class of issues on the host side of NCM. |
| In the Linux kernel, the following vulnerability has been resolved:
usb: gadget: f_phonet: fix skb frags[] overflow in pn_rx_complete()
A broken/bored/mean USB host can overflow the skb_shared_info->frags[]
array on a Linux gadget exposing a Phonet function by sending an
unbounded sequence of full-page OUT transfers.
pn_rx_complete() finalizes the skb only when req->actual < req->length,
where req->length is set to PAGE_SIZE by the gadget. If the host always
sends exactly PAGE_SIZE bytes per transfer, fp->rx.skb will never be
reset and each completion will add another fragment via
skb_add_rx_frag(). Once nr_frags exceeds MAX_SKB_FRAGS (default 17),
subsequent frag stores overwrite memory adjacent to the shinfo on the
heap.
Drop the skb and account a length error when the frag limit is reached,
matching the fix applied in t7xx by commit f0813bcd2d9d ("net: wwan:
t7xx: fix potential skb->frags overflow in RX path"). |
| In the Linux kernel, the following vulnerability has been resolved:
usb: gadget: renesas_usb3: validate endpoint index in standard request handlers
The GET_STATUS and SET/CLEAR_FEATURE handlers extract the endpoint
number from the host-supplied wIndex without any sort of validation.
Fix this up by validating the number of endpoints actually match up with
the number the device has before attempting to dereference a pointer
based on this math.
This is just like what was done in commit ee0d382feb44 ("usb: gadget:
aspeed_udc: validate endpoint index for ast udc") for the aspeed driver. |
| In the Linux kernel, the following vulnerability has been resolved:
smb: client: fix off-by-8 bounds check in check_wsl_eas()
The bounds check uses (u8 *)ea + nlen + 1 + vlen as the end of the EA
name and value, but ea_data sits at offset sizeof(struct
smb2_file_full_ea_info) = 8 from ea, not at offset 0. The strncmp()
later reads ea->ea_data[0..nlen-1] and the value bytes follow at
ea_data[nlen+1..nlen+vlen], so the actual end is ea->ea_data + nlen + 1
+ vlen. Isn't pointer math fun?
The earlier check (u8 *)ea > end - sizeof(*ea) only guarantees the
8-byte header is in bounds, but since the last EA is placed within 8
bytes of the end of the response, the name and value bytes are read past
the end of iov.
Fix this mess all up by using ea->ea_data as the base for the bounds
check.
An "untrusted" server can use this to leak up to 8 bytes of kernel heap
into the EA name comparison and influence which WSL xattr the data is
interpreted as. |
| In the Linux kernel, the following vulnerability has been resolved:
ksmbd: validate EaNameLength in smb2_get_ea()
smb2_get_ea() reads ea_req->EaNameLength from the client request and
passes it directly to strncmp() as the comparison length without
verifying that the length of the name really is the size of the input
buffer received.
Fix this up by properly checking the size of the name based on the value
received and the overall size of the request, to prevent a later
strncmp() call to use the length as a "trusted" size of the buffer.
Without this check, uninitialized heap values might be slowly leaked to
the client. |
