| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| A vulnerability has been found in SpaceX Starlink Router Gen 3 2025.11.14.mr64708.3. This affects the function get_status of the component gRPC Management Interface. The manipulation leads to improper access controls. The attack can only be initiated within the local network. The exploit has been disclosed to the public and may be used. The vendor was contacted early about this disclosure but did not respond in any way. |
| A flaw has been found in code-projects Online Food Order System 1.0. The impacted element is an unknown function of the file delete_food_items1.php. Executing a manipulation of the argument checkbox can lead to sql injection. The attack can be executed remotely. The exploit has been published and may be used. |
| A vulnerability was detected in code-projects Online Food Order System 1.0. The affected element is an unknown function of the file edit_food_items.php. Performing a manipulation of the argument dname results in cross site scripting. Remote exploitation of the attack is possible. The exploit is now public and may be used. |
| In the Linux kernel, the following vulnerability has been resolved:
memstick: ms_block: reject a card that reports too many blocks
msb_ftl_initialize() computes the zone count from the card block count
with no bound:
msb->zone_count = msb->block_count / MS_BLOCKS_IN_ZONE;
...
for (i = 0; i < msb->zone_count; i++)
msb->free_block_count[i] = MS_BLOCKS_IN_ZONE;
msb->block_count is a card value. msb_read_boot_blocks() reads
number_of_blocks from the card boot page and byte swaps it.
free_block_count is a fixed int[MS_MAX_ZONES]. MS_MAX_ZONES is 16, so the
valid indices are 0 to 15. The init loop above indexes it by zone_count.
msb_mark_block_used() and msb_mark_block_unused() index it by
pba / MS_BLOCKS_IN_ZONE, for pba up to block_count - 1. A card may report
up to 65535 blocks. A block_count above 8192 (MS_MAX_ZONES *
MS_BLOCKS_IN_ZONE) lets the pba index reach 16. That writes past
free_block_count[] and corrupts struct msb_data. A larger count runs the
init loop past the end too.
A real Memory Stick has at most 16 zones. So it has at most 8192 blocks.
msb_ftl_initialize() now rejects a card that reports more than
MS_MAX_ZONES * MS_BLOCKS_IN_ZONE blocks. |
| In the Linux kernel, the following vulnerability has been resolved:
octeontx2-pf: fix SQB pointer leak on init failure
otx2_init_hw_resources() initializes SQ aura and pool resources before
several later setup steps. On failure, err_free_sq_ptrs only frees SQB
pages, leaving the per-SQ sqb_ptrs arrays behind.
Use otx2_free_sq_res() for the SQ unwind path and let it free sqb_ptrs
even when sq->sqe has not been allocated yet.
The bug was first flagged by an experimental analysis tool we are
developing for kernel memory-management bugs while analyzing
v6.13-rc1. The tool is still under development and is not yet publicly
available. Manual inspection confirms that the bug is still
present in v7.1.1.
An x86_64 allyesconfig build showed no new warnings. As we do not have an
OcteonTX2 PF device and the corresponding AF mailbox setup to test with,
no runtime testing was able to be performed. |
| In the Linux kernel, the following vulnerability has been resolved:
ata: libata-core: Add NOLPM quirk for PNY CS900 1TB SSD
The PNY CS900 1TB SSD (Phison PS3111-S11, DRAM-less) drops off the bus
after entering Device-Initiated Slumber during idle. With the default
med_power_with_dipm policy the link goes down (SStatus 1 SControl 300)
and does not recover, forcing the filesystem read-only. Forcing
max_performance keeps the link stable across prolonged idle.
Add a NOLPM quirk so link power management is disabled for this drive
specifically, leaving it intact for other devices on the host. |
| In the Linux kernel, the following vulnerability has been resolved:
bnx2x: fix potential memory leak in bnx2x_alloc_mem_bp()
If the allocation of fp[i].tpa_info fails, the error path will not free
the struct bnx2x_fastpath allocated earlier, as it is not linked to the
bp structure yet. Fix that by linking it immediately after allocation. |
| In the Linux kernel, the following vulnerability has been resolved:
octeontx2-af: Free BPID bitmap on setup failure
nix_setup_bpids() allocates bp->bpids with rvu_alloc_bitmap(), which uses
a plain kcalloc(). If any of the following devm_kcalloc() allocations for
the BPID mapping arrays fails, the function returns without freeing the
bitmap. Free the BPID bitmap before returning from those error paths. |
| In the Linux kernel, the following vulnerability has been resolved:
net: lan743x: Initialize eth_syslock spinlock before use
lan743x_hardware_init() calls pci11x1x_strap_get_status() during the
PCI11x1x probe sequence. That helper acquires the Ethernet subsystem
hardware lock via lan743x_hs_syslock_acquire(), which relies on
adapter->eth_syslock_spinlock to serialize access.
The spinlock is currently initialized only after the strap status is
read. With CONFIG_DEBUG_SPINLOCK enabled, taking the zeroed initialized
spinlock can trip the spinlock debug check.
Fix by initializing adapter->eth_syslock_spinlock before reading the
strap status so the probe path never attempts to lock an uninitialized
spinlock. |
| In the Linux kernel, the following vulnerability has been resolved:
gpio: mt7621: avoid corruption of shared interrupt trigger state
The bank-shared fields like 'rising' and 'falling' are modified using
non-atomic read-modify-write operations. Since every gpio chip instance
represents an entire bank of 32 pins, if 'mediatek_gpio_irq_type()' is
called concurrently for different IRQs on the same bank a possible overwrite
of each other's configuration is possible. Thus, protect this state with
'gpio_generic_lock_irqsave' lock in the same way it is handled in irp_chip
'mediatek_gpio_irq_mask()' and 'mediatek_gpio_irq_unmask()' callbacks. |
| In the Linux kernel, the following vulnerability has been resolved:
posix-cpu-timers: Use u64 multiplication in update_rlimit_cpu()
update_rlimit_cpu() converts the RLIMIT_CPU value to nanoseconds with
u64 nsecs = rlim_new * NSEC_PER_SEC;
On 32-bit kernels both rlim_new (unsigned long) and NSEC_PER_SEC
(1000000000L) are 32-bit, so the multiplication is performed in unsigned
long and truncated for rlim_new > 4 seconds before being widened to u64.
The same file already casts to u64 for the matching computation in
check_process_timers():
u64 softns = (u64)soft * NSEC_PER_SEC;
As a result, the truncated value is installed into the CPUCLOCK_PROF
expiry cache (nextevt), causing the process CPU timer to be programmed
to fire prematurely for any RLIMIT_CPU soft limit >= 5 seconds. The
actual SIGXCPU/SIGKILL decision in check_process_timers() already casts
to u64 and is therefore correct, so limit enforcement is not broken;
only the expiry-cache programming is wrong. Apply the same cast here so
both paths convert rlim_cur identically.
64-bit kernels are unaffected. |
| In the Linux kernel, the following vulnerability has been resolved:
mmc: sdhci-esdhc-imx: use pm_runtime_resume_and_get() in suspend
Replace pm_runtime_get_sync() with pm_runtime_resume_and_get() to
simplify error handling. pm_runtime_resume_and_get() automatically
drops the usage counter on failure, avoiding the need for a separate
pm_runtime_put_noidle() call. If it fails, the device is unclocked and
accessing hardware registers would cause a kernel panic, so return the
error immediately. |
| In the Linux kernel, the following vulnerability has been resolved:
mmc: sdhci-esdhc-imx: fix esdhc_change_pinstate() to allow default state restore
esdhc_change_pinstate() checks for pins_100mhz and pins_200mhz at the
top of the function and returns -EINVAL if either is not defined. This
prevents the default case from ever being reached, which means devices
with a sleep pinctrl state but without high-speed pin states (100mhz/
200mhz) can never restore their default pin configuration.
Move the IS_ERR checks for pins_100mhz and pins_200mhz into their
respective switch cases. |
| In the Linux kernel, the following vulnerability has been resolved:
reset: sunxi: fix memory region leak on ioremap failure
In sunxi_reset_init(), when ioremap() fails, the memory region obtained
via request_mem_region() is not released, leading to a resource leak.
Add an err_mem_region label to properly release the memory region before
freeing the data structure. |
| In the Linux kernel, the following vulnerability has been resolved:
pmdomain: mediatek: Fix possible nullptr KP in HWV cleanup/on-check
Should probe fail for HW_VOTER type power domains, this driver was
unconditionally trying to perform cleanup for DIRECT_CTL domains,
but only after checking if the target domain is powered on... with
the DIRECT_CTL scpsys_domain_is_on() code again.
And there's more: the scpsys_domain_is_on() function is also being
unconditionally used in the probe path, for any power domain that
has flag MTK_SCPD_KEEP_DEFAULT_OFF!
This bug was never experienced by anyone because the HWV domains
never failed probe, and because none of those is declared with the
aforementioned flag - but it's still something critical.
In order to fix this, add a check for MTCMOS Type and, based on
that, call the correct functions for an "is on" check, and also
do the same for the cleanup path, calling the correct functions
for the "power off" action.
For the latter, since there's a call to pm_genpd_remove() right
before calling power_off, be cautious and add a variation of the
power off functions (with a _internal suffix) for those to get a
pointer to scpsys_domain instead of one to generic_pm_domain as,
even if that's still working, this is way too much fragile and
would break at some point. |
| In the Linux kernel, the following vulnerability has been resolved:
cgroup/cpuset: rebind mm mempolicy to effective_mems, not mems_allowed
Creating a child cpuset where cpuset.mems is never set leads to a div/0
when a VMA mempolicy with MPOL_F_RELATIVE_NODES rebinds in response to a
CPU hotplug event.
Reproduction steps:
1) Create a cgroup w/ cpuset controls (do not set cpuset.mems)
2) Move the task into the child cpuset
3) Create a VMA mempolicy for that task with MPOL_F_RELATIVE_NODES
4) unplug and hotplug a cpu
echo 0 > /sys/devices/system/cpu/cpu1/online
echo 1 > /sys/devices/system/cpu/cpu1/online
5) mempolicy rebind does a div/0 in mpol_relative_nodemask on the
call to __nodes_fold()
The cpuset code passes (cs->mems_allowed) which is not guaranteed to have
nodes to the rebind routine. Use cs->effective_mems instead, which is
guaranteed to have a non-empty nodemask once we reach that code path.
[ david: add a comment, slightly rephrase description ] |
| In the Linux kernel, the following vulnerability has been resolved:
s390/diag: Add missing array_index_nospec() call to memtop_get_page_count()
'level' is user space controlled and used to read from an array. Add the
missing array_index_nospec() call to prevent speculative execution. |
| In the Linux kernel, the following vulnerability has been resolved:
riscv: Prevent NULL pointer dereference in machine_kexec_prepare()
A NULL pointer dereference issue is noticed in riscv's
machine_kexec_prepare(), where image->segment[i].buf might be NULL and
copied unchecked.
The NULL buf comes from ima_add_kexec_buffer(), where kbuf is added by
kexec_add_buffer(), but kbuf.buffer is NULL, then it is copied without
a check in machine_kexec_prepare():
kexec_file_load
-> kimage_file_alloc_init()
-> kimage_file_prepare_segments()
-> ima_add_kexec_buffer()
-> kexec_add_buffer()
-> machine_kexec_prepare()
-> memcpy()
Address this by adding a check before the data copy attempt. |
| In the Linux kernel, the following vulnerability has been resolved:
Input: ims-pcu - fix use-after-free and double-free in disconnect
ims_pcu_disconnect() only intended to perform cleanup when the primary
(control) interface is unbound. However, it currently relies on the
interface class to distinguish between control and data interfaces.
A malicious device could present a data interface with the same class
as the control interface, leading to premature cleanup and potential
use-after-free or double-free.
Switch to verifying that the interface being disconnected is indeed
the control interface. |
| In the Linux kernel, the following vulnerability has been resolved:
scsi: elx: efct: Fix refcount leak in efct_hw_io_abort()
When efct_hw_reqtag_alloc() fails in efct_hw_io_abort(), the error path
returns -ENOSPC without releasing the reference obtained via
kref_get_unless_zero() earlier in the function. All other error paths
correctly drop the reference. This causes a permanent reference leak on the
io_to_abort object.
Additionally, the abort_in_progress flag is left set to true on this path,
which means future abort attempts for the same I/O will immediately return
-EINPROGRESS even though the abort was never submitted, effectively
blocking recovery.
Fix this by adding the missing kref_put() call and reset abort_in_progress
to false, matching the cleanup done in the efct_hw_wq_write() failure path
below. |
